Hotpoint Washing Machine Manuals

Most Common Error Codes (All Models)

• F01 / F1: Motor triac fault – check wiring to motor; possible control board issue; requires technician.
• F02 / F2: Motor jammed or tacho fault – check for blocked motor; inspect tacho generator; free drum if stuck.
• F03 / F3: NTC (temperature sensor) fault – sensor open/short circuit; replace NTC.
• F05 / F5: Pressure switch jammed on full / drain issue – clean pump filter; check drain hose; test pressure switch.
• F06 / F6: Door lock fault – door not recognised as closed; check lock mechanism and wiring.
• F07 / F7: Heater relay stuck – control board fault; possible heater element issue.
• F08 / F8: Heater relay cannot be activated – wiring or board fault.
• F09 / F9: Software / EEPROM error – reset by unplugging; may need new control board.

Recent Models (2023–2026) & Smart Tech

• F12: No communication between boards – check wiring harness; reset appliance.
• F13 / F14: Dryer temperature sensor faults (washer-dryer models).
• H20: Not filling with water – check inlet valves, hoses, and water supply; clean inlet filters.
• Door Locked: After cycle – wait 2-5 minutes for lock to release; if stuck, emergency door release procedure.

General Washing Machine Specific

• Not draining: Clean pump filter (bottom front); check drain hose not kinked or too high.
• Not spinning: Unbalanced load; redistribute clothes; check for F02/F05 errors.
• Leaking: Check door seal; inspect hoses; clean detergent drawer.
• No power / not starting: Check fuse; ensure door fully closed; reset by unplugging 10 min.

Safety note: Always unplug before cleaning filter or inspecting parts. Never bypass door lock. For electrical faults, consult qualified technician.