Hotpoint washing machine WMBF 963P UK manual

The Hotpoint WMBF 963P is a freestanding washing machine with a 9kg capacity, 1600 RPM spin speed, and an A+++ energy rating. It features multiple wash programmes, including a 15-minute quick wash, anti-allergy cycle, and steam refresh option. Equipped with digital display, delay start, child lock, and AquaStop leak protection. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: 9kg drum, digital control panel, detergent dispenser, filter access, adjustable feet, water inlet hoses, drain hose.

Installation

Unpack and remove all transit bolts. Place on level, solid floor.

1. Remove transit bolts: Use spanner to remove four bolts from rear; keep for future moves.
2. Adjust feet: Turn feet to level machine; use spirit level to check.
3. Connect water supply: Attach inlet hoses to cold water tap (and hot if applicable). Ensure washers are fitted.
4. Connect drain hose: Place into standpipe or sink; secure with hook if provided.
5. Plug into grounded power socket.

WARNING! Do not install in areas prone to freezing. Ensure transit bolts are removed before use to prevent damage.

First-Time Setup

Before first wash, run a maintenance cycle.

1. Power on machine: Plug in and press power button.
2. Run empty wash: Select "Drum Clean" or a 90°C cotton cycle without laundry to remove residues.
3. Set preferences: Use control dial and buttons to set default options like spin speed or temperature.
4. Load detergent: Fill dispenser drawers as per detergent manufacturer's instructions.

CAUTION! Ensure all packaging and protective films are removed. Check hoses for leaks during first use.

Specifications

• Model: WMBF 963P UK
• Capacity: 9kg
• Spin Speed: 1600 RPM (adjustable)
• Energy Class: A+++
• Water Consumption: Approx. 45 litres per cycle (typical)
• Programmes: Cotton, Synthetics, Delicates, Wool, Quick 15, Anti-Allergy, Steam, Drum Clean
• Dimensions (HxWxD): 850mm x 600mm x 590mm
• Power Supply: 220-240V, 50Hz, 10A
• Noise Level: Wash: 53 dB, Spin: 75 dB

Controls and Settings

Control Panel: Power button, programme dial, digital display, start/pause, option buttons.

Programme Dial: Select from Cotton, Eco Cotton, Synthetics, Delicates, Wool, Hand Wash, Quick 15, Anti-Allergy, Steam Refresh, Drum Clean.

Options: Temperature selection (Cold to 90°C), Spin speed (0 to 1600 RPM), Delay Start (1-24 hours), Extra Rinse, Pre-Wash. Display: Shows time remaining, cycle phase, selected options, and error codes. Child Lock: Press and hold specific buttons (check manual) for 3 seconds to activate/deactivate.

Connecting Water & Drain

Water Inlet: Cold fill only (or hot/cold if model has dual inlet). Drain: Standpipe, sink, or floor drain.

1. Turn off water supply before connecting hoses.
2. Connect inlet hoses: Screw onto taps; hand-tighten plus a quarter turn with pliers. Do not overtighten.
3. Position drain hose: Insert into standpipe (min. 60cm height) or secure over sink edge.
4. Check for leaks: Run a short rinse cycle and inspect connections.

Tip: Use new hoses if possible; do not reuse old, worn hoses.

Using Wash Programmes

Select programme based on fabric type and soil level.

1. Load laundry: Do not overload; distribute evenly.
2. Add detergent: Use drawer compartments I (pre-wash), II (main wash), * (fabric softener).
3. Select programme: Turn dial to desired programme.
4. Adjust options: Set temperature, spin speed, extra rinse if needed.
5. Start: Press start/pause button. Display shows time remaining.
6. Pause/change: Press start/pause to stop; you may change options if cycle hasn't progressed too far.
7. End of cycle: Machine beeps; door unlocks (may take a few minutes). Remove laundry promptly.

WARNING! Do not open door during high-temperature washes; steam may cause burns. Check pockets for objects.

Special Features

Quick 15: Fast wash for 1-2 lightly soiled items. Anti-Allergy: Heats water to eliminate dust mites and allergens. Steam Refresh: Uses steam to freshen clothes; no detergent needed. Delay Start: Programme starts later; useful for off-peak energy times. Child Lock: Locks controls to prevent tampering.

Care & Cleaning

Regular maintenance ensures longevity.

1. Clean detergent drawer: Pull out, rinse under warm water, dry, and reinsert.
2. Clean door seal: Wipe rubber gasket to remove lint and residue; leave door ajar after use to dry.
3. Clean filter: Locate behind kickplate; turn anti-clockwise to remove; clear debris.
4. Run Drum Clean: Monthly, use dedicated programme or 90°C cotton cycle with drum cleaner.

CAUTION! Unplug before cleaning. Do not use abrasive cleaners on surfaces.

Regulatory Information

Complies with UK Electrical Equipment (Safety) Regulations 2016. CE marked. Waste Electrical and Electronic Equipment (WEEE): Do not dispose with household waste; recycle at designated facility. Manufacturer: Hotpoint, a Haier company. For support, visit www.hotpoint.co.uk or contact 03448 113 113.

Troubleshooting

Reset: Unplug for 2 minutes, then restart.

Service: 03448 113 113; www.hotpoint.co.uk