Hotpoint washing machine BHWDD 74 (UK) manual

The Hotpoint BHWDD 74 is a freestanding 7kg capacity washing machine with 1400 RPM spin speed, featuring Hotpoint's AquaCare™ technology for reduced water usage, Anti-Stain™ programs, Direct Spray for even detergent distribution, and a Delay Timer. It includes multiple wash programs for cotton, synthetics, delicates, wool, and quick washes. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: 7kg drum, Electronic control panel, Detergent drawer, Door with safety lock, Water inlet hoses, Drain hose, Adjustable feet, Power cord.

Installation

Unpack and remove all transit bolts and packaging. Place on stable, level floor.

1. Connect water supply: Attach inlet hoses to cold water tap (and hot if applicable) using supplied washers.
2. Connect drain hose: Place into standpipe, sink, or hook over edge (minimum height 60cm, maximum 100cm).
3. Level the machine: Adjust the four feet using a spanner to ensure machine is stable.
4. Plug into a grounded 220-240V AC, 50Hz power outlet.

WARNING! Do not remove transit bolts before moving to final location. Ensure water connections are tight to prevent leaks.

First-Time Setup

Before first use, run a maintenance wash to clear any residual water.

1. Remove transit bolts: Use spanner to remove all bolts from rear panel and fit covers.
2. Check hoses: Ensure no kinks in water inlet or drain hoses.
3. Run initial wash: Select the "Drum Clean" or "Cotton 90°C" program without laundry and run empty with detergent.
4. Set preferences: Use control dial and buttons to set desired default options if available.

CAUTION! Do not use the machine without removing all transit bolts. This can cause severe damage.

Specifications

• Capacity: 7kg (dry cotton).
• Spin Speed: Up to 1400 RPM.
• Energy Rating: A+++.
• Water Consumption: Approx. 42 litres per cycle (cotton 60°C).
• Noise Level: Washing: 53 dB(A), Spinning: 73 dB(A).
• Dimensions (HxWxD): 85cm x 60cm x 60cm.
• Programs: Cotton, Synthetics, Delicates, Wool, Anti-Stain, Quick Wash, Drum Clean.
• Special Functions: Delay Start, Extra Rinse, Reduced Creases, Speed Wash.
• Power Supply: 220-240V AC, 50Hz.
• Max Load: See program guide for weight limits per fabric type.

Controls and Settings

Control Panel: Program dial, Start/Pause button, Option buttons (Delay, Extra Rinse, etc.), Digital display, Child Lock button.

Program Dial: Select from Cotton (various temperatures), Synthetics, Delicates, Wool, Anti-Stain, Quick Wash (30°C/Cold), Rinse & Spin, Spin Only, Drum Clean.

Options: DELAY (1-24 hours), EXTRA RINSE, REDUCED CREASES, SPEED WASH. Display: Shows selected program, remaining time, temperature, spin speed, and active options. Child Lock: Press and hold for 3 seconds to activate/deactivate.

Connecting Water & Drain

Water Inlet: Connect hoses to cold (mandatory) and hot (optional) taps. Drain: Hose to standpipe or sink.

1. Ensure taps are off before connecting hoses.
2. Use only supplied hoses; do not reuse old ones.
3. Secure drain hose to prevent slipping during spin.
4. After connection, turn taps on fully and check for leaks.

Tip: Install a drip tray or leak detector for added safety, especially on wooden floors.

Using Wash Programs

Select program based on fabric type and soil level.

1. Load laundry: Open door, load items loosely without overfilling.
2. Add detergent: Pour into main wash compartment (II) of drawer. Pre-wash or softener in other compartments if needed.
3. Select program: Turn dial to desired program (e.g., Cotton 40°C).
4. Set options: Press option buttons (e.g., Extra Rinse) as required.
5. Start: Press Start/Pause. Door locks and cycle begins.
6. Pause/Modify: Press Start/Pause to pause; you may add items if door unlocks. Change options only before starting.
7. End of cycle: Signal sounds. Wait for door lock symbol to disappear before opening.

WARNING! Do not force door open during wash or spin. Ensure small items are in a wash bag.

Special Functions

Delay Timer: Set 1-24 hours delay. Anti-Stain Programs: Select specific program for stain type. Child Lock: Prevents changes during cycle. Drum Clean: Run monthly with detergent to prevent mould.

Care & Cleaning

Unplug before maintenance. Clean detergent drawer monthly; remove and rinse under tap. Wipe door seal and glass to remove lint/debris. Clean filter periodically (located behind bottom access panel).

CAUTION! Do not use abrasive cleaners or solvents on surfaces. Keep filter area clear of objects.

Regulatory Information

Complies with UK Electrical Equipment (Safety) Regulations 2016 and relevant EU directives. Energy label according to EU Regulation 2019/2017. Waste Electrical and Electronic Equipment (WEEE): Do not dispose with household waste; recycle appropriately. For support, visit www.hotpointservice.co.uk or contact 03448 113 113.

Troubleshooting

Reset: Unplug for 5 minutes, then restart.

Service: 03448 113 113; www.hotpointservice.co.uk