Hotpoint Washing Machine NWS 7469 WK SPT Manual

The Hotpoint NWS 7469 WK SPT is a 7kg capacity freestanding washing machine with 1400 RPM spin speed, featuring multiple wash programs, energy efficiency class A+++, AquaStop leak protection, direct injection motor, and electronic controls. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Water & Drain 7. Using Wash Programs 8. Special Functions 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Electronic control panel, detergent dispenser, drum with 7kg capacity, AquaStop system, adjustable feet, filter access.

Feature	Description
Capacity	7kg laundry load
Spin Speed	Up to 1400 RPM
Energy Rating	A+++ (most efficient)
AquaStop	Leak protection system
Motor	Direct injection for quiet operation
Programs	15 wash programs including Cotton, Synthetic, Delicates
Display	LED digital display with time remaining
Delay Start	Up to 24 hours
Child Lock	Safety lock function
Quick Wash	30-minute program for small loads

Installation

Unpack and remove transit bolts. Place on level floor.

Remove transit bolts: Use spanner to remove 4 bolts at rear; keep for future moves.
Adjust feet: Turn feet to level machine; use spirit level.
Connect water supply: Attach inlet hoses to hot/cold taps (blue=cold, red=hot).
Connect drain hose: Place in standpipe or sink (minimum height 60cm).
Plug into grounded power outlet.

WARNING! Do not install in areas below 0°C. Ensure transit bolts are removed before use.

First-Time Setup

Before first wash, run a maintenance cycle.

Check installation: Ensure machine is level and hoses secure.
Open water taps: Turn both taps fully open.
Run empty wash: Select Cotton 90°C program without detergent.
Set preferences: Use control dial to select language, time, etc.
Load detergent: Fill dispenser compartments as per instructions.

CAUTION! Never use machine without removing transit bolts—risk of damage.

Specifications

Model: NWS 7469 WK SPT
Capacity: 7kg (dry weight)
Dimensions (HxWxD): 85cm x 60cm x 60cm
Spin Speed: 1400 RPM (adjustable)
Energy Class: A+++
Water Consumption: Approx. 45 litres per cycle (cotton 60°C)
Power Supply: 220-240V, 50Hz
Programs: 15 including Eco, Wool, Sport, Quick Wash
Noise Level: 53 dB (washing), 73 dB (spinning)
Weight: 68kg

Controls and Settings

Control Panel: Program dial, Start/Pause button, Option buttons (Delay, Speed, Temp), Display.

Program Dial: Turn to select wash programs (Cotton, Synthetic, Delicates, Wool, etc.).

Options: Adjust spin speed (400-1400 RPM), temperature (cold to 90°C), delay start (1-24h). Display: Shows time remaining, selected options, error codes. Buttons: START/PAUSE to begin/pause cycle; CHILD LOCK (press 3 sec to activate).

Connecting Water & Drain

Water Inlet: Two hoses (hot & cold) with filters. Drain: Hose with U-bend.

Connect hoses: Screw onto taps; ensure washers are fitted.
Check filters: Clean inlet filters periodically.
Position drain hose: Secure in standpipe (max height 100cm).
Test: Run quick program to check for leaks.

Tip: Use only genuine Hotpoint hoses; do not extend drain hose beyond 150cm.

Using Wash Programs

Select program based on fabric type and soil level.

Load laundry: Do not exceed 7kg; distribute evenly.
Add detergent: Use dispenser (I=pre-wash, II=main wash, *=fabric softener).
Select program: Turn dial (e.g., Cotton for towels/bedding).
Adjust options: Set temperature, spin speed, delay if needed.
Start: Press START/PAUSE; door locks automatically.
End of cycle: Signal sounds; door unlocks after 2 minutes.
Unload: Remove laundry promptly; leave door ajar to dry.

WARNING! Do not open door during wash—hot water risk. Wait for unlock signal.

Special Functions

Delay Start: Set 1-24h delay. Child Lock: Press for 3 sec to lock controls. Extra Rinse: Adds rinse cycle for sensitive skin. Speed Wash: Reduces time for lightly soiled loads. Eco 40-60: Energy-saving program for 40-60°C washes.

Care & Cleaning

Monthly maintenance: Clean detergent dispenser, door seal, and filter.

Dispenser: Remove and rinse under warm water.
Door seal: Wipe with damp cloth; remove debris.
Filter: Turn drain pump filter anti-clockwise; clean under running water.
Drum: Run hot wash (90°C) without laundry monthly.

CAUTION! Unplug before cleaning filter. Do not use abrasive cleaners.

Regulatory Information

CE compliant. Meets EU Ecodesign and Energy Label regulations. Waste electrical products must not be disposed of with household waste. Please recycle according to local regulations. For support, visit www.hotpoint.co.uk or contact 03448 113 113.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Machine won't start	Door not closed/power	Close door firmly; check plug/power; activate child lock off.
No water intake	Taps closed/filter blocked	Open taps; clean inlet filters; check hose kinks.
Water doesn't drain	Drain blocked/pump filter	Clean pump filter; ensure drain hose height <100cm.
Excessive vibration	Transit bolts/uneven load	Ensure transit bolts removed; redistribute laundry; level feet.
Error code on display	Various faults	Consult manual error code list; unplug for 5 min then retry.

Reset: Unplug for 5 minutes to reset electronics.

Service: 03448 113 113; www.hotpoint.co.uk