Hotpoint washing machine EU NDB R6369 WA IT manual

The Hotpoint EU NDB R6369 WA IT is a freestanding washing machine with a 6 kg load capacity, energy efficiency class A, multiple wash programs, electronic controls, delay start, child lock, and safety features. It operates on standard European household power (220-240V, 50Hz). Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: Electronic control panel, detergent dispenser, drum, door with safety lock, adjustable feet, water inlet hoses, drain hose.

Installation

Unpack and remove transit bolts. Place on stable, level floor.

1. Remove transit bolts: Use spanner to remove bolts at rear; keep for future moves.
2. Connect water supply: Attach inlet hoses to cold water tap (and hot if applicable).
3. Connect drain hose: Place in sink or secure to standpipe.
4. Level the machine: Adjust feet using a wrench; use spirit level.
5. Plug into grounded power outlet.

WARNING! Do not install in wet areas. Ensure transit bolts are removed to prevent damage.

First-Time Setup

Before first use, run a wash cycle without laundry.

1. Check installation: Ensure hoses are secure and machine is level.
2. Power on: Plug in and press POWER button.
3. Run initial cycle: Select Cotton program at 90°C without laundry to clean drum.
4. Set preferences: Use OPTIONS button to set beep volume, end signal.
5. Load detergent: Fill dispenser compartments as needed.

CAUTION! Do not use machine without removing transit bolts. Use two people for moving.

Specifications

• Model: Hotpoint EU NDB R6369 WA IT
• Capacity: 6 kg
• Energy Rating: A
• Spin Speed: 1200 rpm (max)
• Water Pressure: 0.5 - 8 bar
• Programs: 12 programs including Cotton, Synthetics, Delicates, Wool, Quick (30°C), Rinse & Spin, Drain
• Dimensions (HxWxD): 85 x 60 x 55 cm
• Power Supply: 220-240V, 50Hz
• Power Consumption: 2000 W (max)
• Noise Level: Wash: 59 dB, Spin: 77 dB

Controls and Settings

Control Panel: POWER button, Program selector knob, START/PAUSE, OPTIONS button, Delay Start button, Child Lock button.

Display: Shows selected program, time remaining, spin speed, temperature, and option icons.

Program Selection: Turn knob to choose (Cotton, Synthetics, Delicates, Wool, Quick Wash, etc.). Options: Press OPTIONS to select extra rinse, pre-wash, eco mode, etc. Delay Start: Press DELAY to set start time (1-24 hours). Child Lock: Press and hold CHILD LOCK for 3 seconds to enable/disable. Temperature: Auto-selected per program; adjustable on some programs. Spin Speed: Auto-selected; adjustable or can be set to No Spin.

Connecting Water & Drain

Water Inlet: Connect hoses to cold water tap (blue marker) and hot if available (red marker). Drain: Place hose in sink or secure to standpipe (max height 100 cm).

1. Ensure water taps are off before connecting hoses.
2. Use only supplied hoses; do not reuse old ones.
3. Secure drain hose to avoid slipping or flooding.
4. Check for leaks after first connection.

Tip: Use hose clips for drain hose. Do not kink hoses.

Using Wash Programs

Select program based on fabric type and soil level.

1. Load laundry: Do not exceed 6 kg; distribute evenly.
2. Add detergent: Open dispenser; add to correct compartments (I: pre-wash, II: main wash, *: softener).
3. Select program: Turn knob to desired program (e.g., Cotton for linens).
4. Set options: Press OPTIONS for extra rinse, etc.
5. Start: Press START/PAUSE; door locks and cycle begins.
6. Pause/Stop: Press START/PAUSE to pause; turn knob to reset to stop.
7. After cycle: Door unlocks; remove laundry; leave door ajar to dry drum.

WARNING! Do not open door during wash; wait for unlock signal. Unbalanced load may cause noise; redistribute laundry.

Special Functions

Delay Start: Set start time (1-24 hours). Child Lock: Locks controls during operation (press and hold 3 sec). Extra Rinse: Adds rinse cycle for sensitive skin. Pre-wash: For heavily soiled loads. Eco Mode: Reduces energy/water (longer cycle). Rinse & Spin: For hand-washed items. Drain Only: Drains water without spinning.

Care & Cleaning

Clean detergent dispenser monthly: Pull out, rinse under tap. Clean drum: Run Cotton program at 90°C without laundry monthly. Clean door seal: Wipe with damp cloth; remove debris. Clean filter: Locate at front bottom; turn drain cap slowly to release water, then remove filter and clean.

CAUTION! Unplug before cleaning. Do not use abrasive cleaners.

Regulatory Information

CE marked; complies with EU directives for safety and electromagnetic compatibility. Energy label according to EU regulations. Copyright © Hotpoint; trademarks of Whirlpool Corporation. For support, visit www.hotpoint.eu or contact local service center.

Troubleshooting

Reset: Unplug for 5 minutes, then restart.

Service: Contact authorized Hotpoint service center.