Hotpoint Washing Machine WML560P Manual

The Hotpoint WML560P is a freestanding washing machine with a 6kg capacity, 1200 RPM spin speed, A+++ energy rating, and multiple wash programs. It features a digital display, delay start, child lock, quick wash cycles, and anti-allergy options. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Water & Drain 7. Using Wash Programs 8. Special Functions 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Digital control panel, detergent dispenser, drum, filter, water inlet valves, drain pump.

FeatureDescription
Capacity6kg laundry load
Spin SpeedUp to 1200 RPM
Energy RatingA+++ (most efficient)
DisplayDigital LED with time remaining
Programs14 programs including Cotton, Synthetic, Delicates, Quick Wash
Delay StartUp to 24 hours
Child LockPrevents accidental program changes
Anti-AllergySpecial cycle to reduce allergens
Door LockAutomatic during operation
Dimensions (HxWxD)85 x 60 x 55 cm

Installation

Unpack and remove transit bolts. Place on level floor.

  1. Remove transit bolts: Use spanner to remove 4 bolts at rear; keep for future moves.
  2. Connect water supply: Attach inlet hoses to hot/cold taps (blue for cold, red for hot).
  3. Connect drain hose: Place in standpipe or sink; ensure no kinks.
  4. Level the machine: Adjust front feet using spanner; use spirit level.
  5. Plug into grounded power outlet.

WARNING! Do not install in wet areas. Ensure transit bolts are removed before use.

First-Time Setup

Power on machine; run initial empty wash.

  1. Check connections: Ensure water taps are on and hoses secure.
  2. Add detergent: Pour into compartment II (main wash) of dispenser.
  3. Select program: Turn knob to "Cotton 60°C".
  4. Press Start/Pause to begin empty wash cycle (removes residues).
  5. After completion, machine is ready for laundry loads.

CAUTION! Never use without removing transit bolts—risk of damage.

Specifications

Controls and Settings

Control Panel: Program knob, digital display, temperature button, spin speed button, delay start button, start/pause button.

Program Knob: Select from 14 programs. Temperature: Adjust from cold to 90°C. Spin Speed: Adjust from no spin to 1200 RPM. Delay Start: Set 1-24 hours. Start/Pause: Begin or pause cycle. Child Lock: Press and hold for 3 seconds to activate/deactivate.

Display shows: Time remaining, program stage, door lock status, error codes.

Connecting Water & Drain

Water Inlet: Two hoses (hot/cold) with filters. Drain: Hose to standpipe or sink.

  1. Turn off taps before connecting hoses.
  2. Connect hoses: Hand-tighten; do not overtighten.
  3. Check filters: Clean inlet filters if water flow is low.
  4. Drain hose: Maximum height 100cm; secure to avoid slipping.

Tip: Use hose clips for secure drain connection.

Using Wash Programs

Supports various fabrics and soil levels.

  1. Load laundry: Do not exceed 6kg; distribute evenly.
  2. Add detergent: Use compartment I (pre-wash) if needed, II (main wash), III (fabric softener).
  3. Select program: Turn knob (e.g., Cotton, Synthetic, Delicates).
  4. Adjust settings: Temperature, spin speed, delay start as desired.
  5. Press Start/Pause to begin.
  6. After cycle, remove laundry promptly; leave door ajar to dry drum.

WARNING! Do not open door during wash—hot water risk. Wait for door lock light to go off.

Special Functions

Delay Start: Press button repeatedly to set 1-24 hours. Child Lock: Press and hold for 3 seconds; display shows padlock icon. Quick Wash: 30-minute cycle for lightly soiled loads. Anti-Allergy: Extra rinse and higher temperature to reduce allergens. Drum Clean: Run monthly with no laundry to maintain hygiene.

Care & Cleaning

Unplug before cleaning. Wipe exterior with damp cloth. Clean detergent dispenser monthly—remove and rinse under tap. Clean drain filter every 2 months—turn off taps, place towel, open filter cover, drain water, remove debris. Run Drum Clean program monthly.

CAUTION! Do not use abrasive cleaners; keep control panel dry.

Regulatory Information

CE marked; complies with EU directives for safety and electromagnetic compatibility. Energy label according to EU regulations. Copyright © Hotpoint; trademarks of Whirlpool Corporation. For support, visit www.hotpoint.co.uk or contact 0333 305 2265.

Troubleshooting

SymptomPossible CauseCorrective Action
Machine won't startDoor not closed/powerClose door firmly; check plug and power outlet; activate child lock off.
No water intakeTaps off/hose kinkedOpen taps; check hose for kinks; clean inlet filter.
Water not drainingDrain blocked/filterCheck drain hose for blockages; clean pump filter.
Excessive vibrationTransit bolts/levelingEnsure transit bolts removed; re-level machine; redistribute load.
Error code on displayVarious faultsConsult manual error code list; unplug for 5 minutes, restart.

Reset: Unplug for 5 minutes, then restart.

Service: 0333 305 2265; www.hotpoint.co.uk

Hotpoint Washing Machine WML560P Manual © - All Rights Reserved 2025