Hotpoint washing machine H8 W946SB UK manual

The Hotpoint H8 W946SB is a freestanding washing machine with 8kg capacity, 1400 RPM spin speed, A+++ energy rating, and multiple wash programs. It features Hotpoint's AquaCare technology for reduced water consumption, Anti-Stain system for tough stains, Direct Spray for even detergent distribution, and a Delay Timer. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: Control panel with rotary dial and digital display, detergent drawer, drum, water inlet hoses, drain hose, adjustable feet, and power cord.

Installation

Unpack and remove transit bolts. Place on level, solid floor.

1. Remove transit bolts: Use spanner to remove 4 bolts at rear; keep for future moves.
2. Adjust feet: Turn feet to level machine; use spirit level to check.
3. Connect water supply: Attach inlet hoses to cold water tap (and hot if applicable).
4. Connect drain hose: Place in standpipe or sink; secure with hook if provided.
5. Plug into grounded power outlet.

WARNING! Do not install in wet areas. Ensure transit bolts are removed before use to prevent damage.

First-Time Setup

Before first wash, run a maintenance cycle.

1. Check installation: Ensure hoses are secure and machine is level.
2. Run empty cycle: Select Cotton 90°C program without laundry; add 1/2 cup of detergent to clean drum.
3. Set preferences: Use control dial to select language, default temperature, spin speed if adjustable.
4. Load laundry: Do not overload; follow capacity guidelines.

CAUTION! Ensure packaging materials are fully removed. Keep children away during installation.

Specifications

• Model: H8 W946SB UK
• Capacity: 8kg (dry weight)
• Spin Speed: 1400 RPM (adjustable)
• Energy Rating: A+++ (scale A+++ to D)
• Water Consumption: Approx. 45 litres per cycle (average)
• Noise Level: 74 dB (washing), 79 dB (spinning)
• Dimensions (HxWxD): 85cm x 60cm x 60cm
• Weight: 70kg
• Programs: 15 programs including Cotton, Synthetic, Delicates, Wool, Quick Wash
• Power Supply: 220-240V, 50Hz, 10A

Controls and Settings

Control Panel: Rotary dial for program selection, digital display, temperature button, spin speed button, start/pause button, option buttons (Delay, Extra Rinse, etc.).

Programs: Cotton (20°C-90°C), Synthetic (30°C-60°C), Delicates (cold-30°C), Wool (cold-30°C), Quick Wash (30°C), Sports, Jeans, Anti-Stain, Drum Clean.

Settings: Temperature selection (cold to 90°C), Spin speed (400-1400 RPM or no spin), Delay Timer (1-24 hours), Extra Rinse, Pre-Wash, Child Lock (press and hold buttons for 3 seconds).

Connecting Water & Drain

Water Inlet: Cold fill only (or hot/cold if model supports). Drain: Standpipe, sink, or floor drain.

1. Turn off water supply before connecting hoses.
2. Attach inlet hoses to taps; hand-tighten, then quarter turn with pliers.
3. Place drain hose in standpipe (60-100cm height) or secure over sink edge.
4. Check for leaks by turning on water briefly before first wash.

Tip: Use hose clips if provided. Do not kink hoses.

Using Wash Programs

Select program based on fabric type and soil level.

1. Sort laundry: Separate colours, fabrics, and soil levels.
2. Load machine: Do not exceed 8kg; distribute evenly.
3. Add detergent: Use drawer compartments I (pre-wash), II (main wash), * (fabric softener).
4. Select program: Turn dial to desired program (e.g., Cotton).
5. Adjust settings: Press temperature or spin buttons to modify if needed.
6. Start: Press start/pause button; display shows time remaining.
7. Pause/stop: Press start/pause to pause; turn dial to reset to stop.
8. Unload: Remove promptly after cycle ends to avoid wrinkles.

WARNING! Do not open door during high-temperature washes; wait for lock light to go off.

Special Functions

Delay Timer: Press Delay button, use +/- to set hours (1-24). Anti-Stain: Select Anti-Stain program for targeted stain removal. Extra Rinse: Adds rinse cycle for sensitive skin. Pre-Wash: For heavily soiled loads; add detergent to compartment I. Child Lock: Press and hold temperature and spin buttons for 3 seconds to activate/deactivate.

Care & Cleaning

Regular maintenance ensures performance and longevity.

1. Clean detergent drawer: Remove monthly; wash in warm water.
2. Clean drum: Run Drum Clean program monthly (or Cotton 90°C empty).
3. Check filters: Clean pump filter every 3 months (see troubleshooting).
4. Wipe exterior: Use damp cloth; do not use abrasive cleaners.

CAUTION! Unplug before cleaning. Do not use steam cleaners.

Regulatory Information

Complies with UK Electrical Equipment Safety Regulations 2016. CE marked. Waste Electrical and Electronic Equipment (WEEE) Directive: Do not dispose with household waste; recycle at designated facility. For support, visit www.hotpoint.co.uk or contact 0333 305 2265 (UK).

Troubleshooting

Reset: Unplug for 5 minutes, then restart. For persistent issues, call support.

Service: 0333 305 2265 (UK); www.hotpoint.co.uk