Hotpoint washing machine FMG 823B EU manual

The Hotpoint FMG 823B EU is a freestanding 8kg capacity washing machine with 1200 RPM spin speed, A+++ energy rating, and multiple wash programs. It features a digital display, delay start, child lock, anti-flood system, and anti-vibration design. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Water & Drain 7. Using Wash Programs 8. Special Functions 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Control panel with digital display, detergent drawer, drum, water inlet valves, drain pump, adjustable feet, and power cord.

Feature	Description
Capacity	8 kg maximum load
Spin Speed	Up to 1200 RPM
Energy Rating	A+++ (most efficient)
Display	Digital LED with time remaining
Programs	15 programs including Cotton, Synthetic, Delicate, Quick Wash
Delay Start	Up to 24 hours
Child Lock	Prevents accidental program changes
Anti-Flood System	AquaStop protection
Anti-Vibration	Stable during spin cycle
Door Lock	Automatic during operation

Installation

Unpack and remove transit bolts. Place on level floor.

Remove transit bolts: Use spanner to remove 4 bolts at rear; keep for future moves.
Position machine: Ensure 5 cm clearance at sides/rear; near water/drain points.
Connect water inlet: Attach hoses to hot/cold taps (blue=cold, red=hot).
Connect drain hose: Place in sink or standpipe (max height 100 cm).
Level the machine: Adjust front feet; use spirit level.
Plug into grounded power outlet.

WARNING! Do not install in wet areas. Ensure transit bolts removed to prevent damage.

First-Time Setup

Before first wash, run a maintenance cycle.

Check installation: Ensure hoses secure, drain positioned, machine level.
Power on: Plug in; press POWER button.
Run empty wash: Select Cotton 90°C program without laundry; add 100 ml detergent.
Set preferences: Use OPTIONS button to set beep volume, default spin speed.
Load laundry: Do not exceed 8 kg; distribute evenly.

CAUTION! Never use without removing transit bolts. Check for leaks after first connection.

Specifications

Model: FMG 823B EU
Capacity: 8 kg (cotton)
Spin Speed: 1200 RPM (adjustable)
Energy Consumption: 0.85 kWh per cycle (Cotton 60°C)
Water Consumption: 52 liters per cycle (Cotton 60°C)
Noise Level: 53 dB (wash), 73 dB (spin)
Dimensions (HxWxD): 85 x 60 x 60 cm
Weight: 70 kg
Voltage: 220-240V, 50Hz
Programs: 15 including Eco 40-60, Wool, Sport, Drum Clean

Controls and Settings

Control Panel: POWER, PROGRAM SELECTOR knob, START/PAUSE, OPTIONS, DELAY START, CHILD LOCK.

Display Icons: Time remaining, spin speed, temperature, delay, child lock, door locked.

Program Selection: Turn knob to desired program (Cotton, Synthetic, Delicate, Quick 30', etc.). Options: Press OPTIONS to adjust spin speed (0-1200), temperature (cold-90°C), extra rinse, pre-wash. Delay Start: Press DELAY to set start time (1-24 hours). Child Lock: Press and hold CHILD LOCK for 3 seconds to enable/disable.

Connecting Water & Drain

Water Inlet: Two hoses (hot/cold) with filters. Drain: Hose with U-bend.

Turn off taps before connecting.
Connect hoses: Screw onto taps; hand-tighten plus half turn with pliers.
Check filters: Ensure inlet filters clean.
Drain hose: Place in standpipe (min diameter 4 cm) or over sink edge.
Secure hose: Use clip provided; avoid kinks.

Tip: Run taps briefly before connecting to flush debris.

Using Wash Programs

Select program based on fabric type and soil level.

Load laundry: Open door; load evenly; close firmly.
Add detergent: Pull drawer; add to compartments I (pre-wash), II (main wash), * (softener).
Select program: Turn knob (e.g., Cotton for linens).
Adjust options: Press OPTIONS to set temperature, spin speed, extra rinse.
Start: Press START/PAUSE; door locks; display shows time remaining.
Pause/change: Press START/PAUSE to pause; wait for door unlock (2 min).
End of cycle: Beep sounds; door unlocks; remove laundry promptly.

WARNING! Do not open door during wash/spin. Wait for drum to stop.

Special Functions

Delay Start: Set start time up to 24 hours. Child Lock: Locks controls when enabled. Extra Rinse: Adds rinse cycle for sensitive skin. Pre-Wash: For heavily soiled loads. Drum Clean: Monthly maintenance program (run empty at 90°C).

Care & Cleaning

Monthly maintenance: Run Drum Clean program. Clean detergent drawer: Remove and wash under tap. Clean door seal: Wipe rubber gasket; remove debris. Clean filter: Locate at front bottom; turn drain cap slowly; drain water; clean filter.

CAUTION! Unplug before cleaning filter. Do not use abrasive cleaners on drum.

Regulatory Information

CE marked; complies with EU directives for safety and electromagnetic compatibility. Energy label according to EU Regulation 2019/2014. Manufacturer: Hotpoint, a Haier company. For support, visit www.hotpoint.eu or contact local service center. Two-year warranty from purchase date.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Machine won't start	Power/door	Check plug; ensure door closed properly; press START firmly.
No water intake	Taps/hoses/filter	Open taps; check hoses for kinks; clean inlet filters.
Water doesn't drain	Drain hose/filter	Check hose for kinks; clean drain filter; ensure standpipe not blocked.
Excessive vibration	Transit bolts/load/feet	Ensure transit bolts removed; redistribute load; level machine.
Error codes (E01-E10)	Various faults	Consult manual; common: E01=door open, E02=drain problem, E04=water intake fault.
Detergent not dispensed	Drawer blocked	Clean detergent drawer compartments; use correct detergent type.

Reset: Unplug for 5 minutes; plug back in.

Service: Contact authorized Hotpoint service; keep model number ready.