Hotpoint washing machine WDL 540 P (UK) manual

The Hotpoint WDL 540 P is a freestanding washing machine with a 5kg load capacity, featuring multiple wash programmes, energy-efficient operation, and user-friendly controls. It includes safety features, installation guidelines, and maintenance instructions. Below are key sections for safety, features, installation, operation, and troubleshooting.

Features at a Glance

Key components: Control panel with programme selector, detergent dispenser, door lock, water inlet valves, drain pump, and adjustable feet.

Installation

Unpack and inspect contents. Place on a solid, level floor.

1. Remove transit bolts: Use spanner to remove bolts at rear; keep for future moves.
2. Connect water supply: Attach inlet hose to cold water tap (3/4” thread). Ensure washers are fitted.
3. Connect drain hose: Place into standpipe or sink; secure with provided hook if needed.
4. Level the machine: Adjust feet using a spanner; use spirit level to check.
5. Plug into a grounded 230V AC power outlet.

WARNING! Do not install in areas prone to freezing or direct sunlight. Ensure all connections are secure to prevent leaks.

First-Time Setup

Before first use, run a wash cycle without laundry to clean the drum.

1. Ensure machine is properly installed and levelled.
2. Turn on water supply and power.
3. Open detergent dispenser and add a small amount of detergent to the main wash compartment.
4. Select the “Cotton” programme at 60°C without pre-wash.
5. Press Start/Pause to begin the cycle.
6. After completion, the machine is ready for normal use.

CAUTION! Do not load laundry during the first cleaning cycle. Ensure the door is properly closed.

Specifications

• Model: Hotpoint WDL 540 P (UK)
• Capacity: 5kg
• Dimensions (HxWxD): 85cm x 60cm x 54cm
• Voltage/Frequency: 230V AC, 50Hz
• Power Consumption: Max 2100W (heating)
• Water Pressure: 0.5 bar to 8 bar
• Spin Speed: 1000 rpm
• Programmes: 12 programmes including Eco, Quick, and Special care
• Noise Level: Wash: 59 dB(A), Spin: 77 dB(A)
• Weight: 61 kg

Controls and Settings

Control Panel: Programme selector knob, Start/Pause button, Delay Start button, Option buttons (e.g., Extra Rinse, Pre-wash).

Programme Selector: Turn knob to desired programme (Cotton, Synthetics, Delicates, Wool, Quick Wash, etc.). LED indicators show selected options and cycle phase.

Options: Extra Rinse (adds an additional rinse cycle), Pre-wash (for heavily soiled items), Reduced Creases (slower final spin), Delay Start (set start time up to 24 hours).

Child Lock: Press and hold Delay Start and Extra Rinse buttons for 3 seconds to activate/deactivate.

Connecting Water & Drain

Water Inlet: Cold fill only. Connect hose to tap with rubber seal. Drain: Hose can be placed in standpipe (min 60cm, max 100cm height) or over sink edge.

1. Ensure water tap is off before connecting hose.
2. Check hose for kinks or damage.
3. Secure drain hose to prevent slipping.
4. After connection, open tap slowly and check for leaks.

Tip: Use only the provided hoses. Do not extend or replace with non-genuine parts.

Using Wash Programmes

Supports various fabrics and soil levels.

1. Sort laundry by colour and fabric type.
2. Load machine: Do not exceed 5kg; distribute evenly.
3. Add detergent: Use dispenser compartments (I: pre-wash, II: main wash, *: fabric softener).
4. Select programme: Turn knob to desired setting.
5. Select options: Press relevant buttons (e.g., Extra Rinse).
6. Set Delay Start if required.
7. Press Start/Pause to begin cycle.
8. At end of cycle, remove laundry promptly to avoid creasing.

WARNING! Do not open door during wash or spin; wait until “Door Lock” light is off. Remove all objects from pockets.

Maintenance & Cleaning

Regular cleaning ensures optimal performance and longevity.

• Exterior: Wipe with damp cloth; do not use abrasive cleaners.
• Detergent Dispenser: Remove monthly; rinse under warm water.
• Door Seal: Wipe clean after cycles to remove lint and residue.
• Drum: Run empty “Cotton” cycle at 90°C monthly with washing machine cleaner.
• Filter: Clean pump filter every 3 months (see Troubleshooting for location).

CAUTION! Unplug machine before cleaning. Do not use steam or high-pressure cleaners.

Safety Information

Read all instructions before use. Keep packaging away from children. This appliance is for household use only.

• Do not use extension cords or adapters.
• Do not wash items soiled with flammable substances.
• Ensure water and electricity are turned off during maintenance.
• Do not sit or stand on the open door.
• Keep pets and children away during operation.

Regulatory Information

Complies with UK and EU safety standards. Waste electrical products should not be disposed of with household waste. Please recycle according to local regulations. For service or support, contact Hotpoint Customer Care: 03448 113 113 (UK) or visit www.hotpoint.co.uk. This manual is copyright © Hotpoint.

Troubleshooting

Reset: Unplug for 5 minutes, then restart.

Service: 03448 113 113; www.hotpoint.co.uk