Hotpoint washing machine WMTF 722 H UK manual

The Hotpoint WMTF 722 H is a freestanding 7kg washing machine with an A+++ energy rating, 1400 RPM spin speed, and multiple wash programs. It features Hotpoint's Anti-Stain technology, a delay timer, a quick wash cycle, and is designed for UK household use. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Water & Drain 7. Using Wash Programs 8. Care & Maintenance 9. Regulatory Information 10. Troubleshooting

Features at a Glance

Key components: 7kg drum capacity, LED display, program selector knob, detergent dispenser, filter access, adjustable feet, inlet hoses.

Feature	Description
Anti-Stain Technology	Automatic treatment for common stains (wine, grass, mud)
Quick Wash	30-minute cycle for lightly soiled loads
Delay Timer	Delay start up to 24 hours
1400 RPM Spin	High spin speed for reduced drying time
A+++ Energy Rating	Most efficient energy class
LED Display	Shows cycle time, delay, and status
Program Knob	Selects wash programs
Detergent Dispenser	Compartments for pre-wash, main wash, softener
Child Lock	Prevents accidental program changes
Adjustable Feet	For levelling the machine

Installation

Unpack and remove transit bolts. Place on solid, level floor.

Remove transit bolts: Use spanner to remove 4 bolts at rear; keep for future moves.
Connect water supply: Attach inlet hoses to cold water tap (and hot if applicable).
Connect drain hose: Place in standpipe or sink (use hook provided).
Level the machine: Adjust feet using spanner; check with spirit level.
Plug into 230V AC power socket.

WARNING! Do not install in areas prone to freezing. Ensure water connections are tight to prevent leaks.

First-Time Setup

Before first wash, run a maintenance cycle.

Check installation: Ensure machine is level, hoses secure, transit bolts removed.
Run empty wash: Select "Drum Clean" or "Cotton 90°C" cycle without laundry.
Set preferences: Use control knob and buttons to set default options if available.
Load detergent: Fill dispenser compartments as per detergent instructions.

CAUTION! Never use machine with transit bolts in place. This can cause severe damage.

Specifications

Capacity: 7kg (dry cotton).
Energy Rating: A+++ (scale A+++ to D).
Spin Speed: 1400 RPM maximum.
Water Pressure: 0.5 - 8 bar (cold fill).
Programs: Cotton, Synthetic, Delicates, Wool, Quick Wash, Anti-Stain, Drum Clean.
Dimensions (HxWxD): 85cm x 60cm x 60cm (approx).
Power Supply: 230V AC, 50Hz, 10A fuse.
Noise Level: Wash: 53 dB, Spin: 75 dB.

Controls and Settings

Control Panel: Program selector knob, Start/Pause button, Delay Timer button, Option buttons (e.g., Extra Rinse, Pre-Wash), Child Lock button, LED display.

Program Knob Positions: Cotton (various temps), Synthetics, Delicates, Wool, Quick Wash (30 min), Anti-Stain, Rinse & Spin, Spin Only, Drum Clean.

Options: Delay Timer (1-24 hrs), Extra Rinse, Reduced Creases, Pre-Wash. Settings: Default temperature, spin speed, and sound can often be adjusted by holding buttons (see manual). Child Lock: Press and hold for 3 seconds to activate/deactivate.

Connecting Water & Drain

Cold water fill only (model specific). Use supplied hoses.

Turn off water supply at tap.
Screw inlet hose to machine (right side, marked).
Connect other end to cold water tap (use washer).
Place drain hose in standpipe (height 60-100 cm) or over sink edge.
Secure with hose hook to prevent slipping.

Tip: Check for leaks by turning on water tap before starting machine.

Using Wash Programs

Select program based on fabric type and soil level.

Load laundry: Do not overload; distribute evenly.
Add detergent: Open dispenser drawer; add to correct compartments.
Select program: Turn knob to desired cycle.
Set options: Press buttons for Extra Rinse, Delay, etc.
Start: Press Start/Pause; door locks and cycle begins.
Pause/Stop: Press Start/Pause to pause; turn knob to reset to stop.
End of cycle: Signal sounds; door unlocks after a short delay.
Clean dispenser: Remove drawer periodically and rinse.

WARNING! Do not open door during high-temperature washes. Wait for lock symbol to disappear.

Care & Maintenance

Regular cleaning prevents odours and maintains performance.

Clean detergent drawer: Remove monthly; wash under tap.
Clean filter: Locate behind kickplate; turn anti-clockwise to remove; clear debris.
Clean door seal: Wipe rubber gasket to remove lint and residue.
Run Drum Clean: Use monthly with dedicated cleaner or 90°C cotton cycle.

CAUTION! Unplug machine before cleaning filter. Have a towel ready for residual water.

Regulatory Information

Complies with UK Electrical Equipment Safety Regulations. CE marked. Waste electrical products should not be disposed of with household waste. Please recycle according to local regulations. For support, visit www.hotpoint.co.uk or contact 03448 113 113.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Machine won't start	Door not closed/power	Ensure door is firmly shut; check plug socket is on; press Start.
No water entering	Taps/blockages	Check water taps are on; inspect inlet hose for kinks; clean filter.
Water not draining	Drain hose/blockage	Check drain hose is not too low or blocked; clean pump filter.
Excessive vibration/noise	Transit bolts/load	Ensure transit bolts removed; redistribute laundry; check machine is level.
Error code on display	Various faults	Consult manual for specific code (e.g., F01, F05). Unplug for 5 mins, retry.

Reset: Unplug for 5 minutes, then restart.

Service: 03448 113 113; www.hotpoint.co.uk