Hotpoint Washing Machine WDPG 8640K Manual

The Hotpoint WDPG 8640K is a freestanding 8kg capacity washing machine with a 1400 RPM spin speed, featuring an A+++ energy rating, multiple wash programs including Eco 40-60, Quick Wash, and Delicates, a delay timer up to 24 hours, child lock, and anti-flood protection. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Water & Drain 7. Using Wash Programs 8. Special Features 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Front-loading drum, electronic control panel, detergent dispenser, water inlet hoses, drain hose, adjustable feet, and child lock.

Feature	Description
Capacity	8 kg (dry laundry weight)
Spin Speed	Up to 1400 RPM
Energy Rating	A+++ (most efficient)
Programs	15 programs including Eco 40-60, Cotton, Synthetics, Delicates
Delay Timer	Up to 24 hours
Child Lock	Locks control panel during operation
Anti-Flood Protection	AquaStop system for leak prevention
Display	LED digital display with time remaining
Door	Large porthole door with safety lock
Dimensions (HxWxD)	850 x 600 x 590 mm

Installation

Unpack and remove all transit bolts and packaging. Place on a solid, level floor.

Connect water supply: Attach inlet hoses to cold water tap (and hot if required).
Connect drain hose: Place into standpipe or sink (max height 100 cm).
Level the machine: Adjust the four feet using a spanner.
Plug into a grounded 220-240V AC power outlet.

WARNING! Do not remove transit bolts before moving into position. Ensure water connections are tight to prevent leaks.

First-Time Setup

Before first use, run a cotton cycle at 90°C without laundry to clean the drum.

Add detergent: Pour into compartment II of the dispenser drawer.
Select program: Turn the program dial to "Cotton 90°C".
Start cycle: Press the Start/Pause button.
Set preferences: Use the option buttons to adjust spin speed, temperature, etc.

CAUTION! Ensure the machine is level to prevent excessive vibration during spin.

Specifications

Model: Hotpoint WDPG 8640K
Capacity: 8 kg
Spin Speed: 1400 RPM (adjustable)
Energy Consumption: 0.95 kWh per cycle (Eco 40-60 at 40°C)
Water Consumption: Approx. 50 liters per cycle (Eco 40-60)
Noise Level: 53 dB (washing), 73 dB (spinning)
Programs: 15 including Cotton, Synthetics, Delicates, Wool, Quick Wash (30 min), Eco 40-60
Special Features: Delay Start (1-24h), Extra Rinse, Pre-Wash, Child Lock
Power Supply: 220-240V AC, 50Hz
Weight: 68 kg

Controls and Settings

Control Panel: Program dial, LED display, Start/Pause button, option buttons (Temp, Spin, Delay, etc.).

Program Dial: Select from 15 programs. Option Buttons: Adjust temperature (cold to 90°C), spin speed (0 to 1400 RPM), delay timer (1-24h), extra rinse, pre-wash. Display: Shows time remaining, selected options, and error codes. Child Lock: Press and hold Temp + Spin buttons for 3 seconds to activate/deactivate.

Connecting Water & Drain

Water Inlet: Connect hoses to taps (blue for cold, red for hot if used). Drain: Secure hose to standpipe or sink.

Turn off water taps before connecting hoses.
Use only the supplied hoses; do not reuse old ones.
Ensure drain hose is not kinked and is at correct height (60-100 cm from floor).

Tip: Check for leaks by running a short cycle after installation.

Using Wash Programs

Select program based on fabric type and soil level.

Load laundry: Do not exceed 8 kg; distribute evenly.
Add detergent: Use compartment I for pre-wash, II for main wash, * for softener.
Select program: Turn dial (e.g., Cotton for towels/bed linen).
Adjust options: Set temperature, spin speed, delay if needed.
Start: Press Start/Pause; door locks automatically.
Pause/Stop: Press Start/Pause to pause; turn dial to reset to stop.
End of cycle: Signal sounds; door unlocks after a few minutes.

WARNING! Do not open door during wash or spin; wait until unlocked.

Special Features

Delay Timer: Set wash to start later (1-24h). Child Lock: Prevents accidental changes. Anti-Flood: AquaStop detects leaks and stops water. Eco 40-60: Energy-efficient program for normally soiled cotton.

Care & Cleaning

Regularly clean detergent dispenser, door seal, and drum. Run "Drum Clean" program monthly (if available) or a 90°C cotton cycle without laundry.

CAUTION! Unplug before cleaning. Wipe exterior with damp cloth; do not use abrasive cleaners.

Regulatory Information

Complies with EU directives for safety (EN 60335), EMC (EN 55014), and energy labeling (EU 2019/2014). Manufactured by Hotpoint, a brand of Whirlpool Corporation. For support, visit www.hotpoint.eu or contact customer service as per local country.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Machine won't start	Door not closed/power	Close door firmly; check plug and power outlet; ensure child lock is off.
No water intake	Taps closed/hose kinked	Open water taps; check hose for kinks; clean inlet filter.
Excessive vibration/noise	Transit bolts/leveling	Ensure all 4 transit bolts removed; adjust feet to level machine.
Water not draining	Drain hose blocked	Check hose for blockages/kinks; clean pump filter.
Error code on display	Various faults	Consult manual error code list; unplug for 5 minutes, then retry.

Reset: Unplug for 5 minutes, then restart.

Service: Contact authorized Hotpoint service center. Do not attempt repairs yourself.