Hotpoint washing machine FMSL 603 EU.L manual

The Hotpoint FMSL 603 EU.L is a freestanding washing machine with a 6 kg load capacity, A+++ energy rating, and 1400 rpm spin speed. It features multiple wash programs, a digital display, delay start, child lock, and anti-flood protection. Designed for standard European household use, it operates on 220-240V, 50Hz. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: Control panel with digital display, detergent drawer, drum, water inlet hoses, drain hose, adjustable feet, and power cord.

Installation

Unpack and remove transit bolts. Place on level floor.

1. Remove transit bolts: Use spanner to remove 4 bolts at rear; keep for future moves.
2. Adjust feet: Turn to level machine; use spirit level.
3. Connect water inlet: Attach hoses to cold water tap (blue) and hot if available (red).
4. Connect drain hose: Place in standpipe or sink edge; secure with hook.
5. Plug into grounded power outlet.

WARNING! Do not install in wet areas. Ensure transit bolts are removed to prevent damage.

First-Time Setup

Plug in and run initial empty wash.

1. Check connections: Ensure hoses are tight and drain hose secure.
2. Open water taps: Turn fully on.
3. Select program: Turn dial to "Cotton 60°C".
4. Add detergent: Pour 100 ml into drawer compartment II.
5. Start: Press Start/Pause; machine will fill, heat, and run for full cycle.
6. Set language: If display shows language options, use Settings button to select.

CAUTION! First wash may have residual water; this is normal.

Specifications

• Model: FMSL 603 EU.L
• Capacity: 6 kg
• Energy Class: A+++
• Annual Energy Consumption: 150 kWh
• Water Consumption: 45 litres per cycle (cotton 60°C)
• Spin Speed: 1400 rpm (adjustable)
• Noise Level: 53 dB (washing), 73 dB (spinning)
• Programs: 15 including Eco 40-60, Wool, Sport, Mix
• Power Supply: 220-240V, 50Hz
• Weight: 68 kg

Controls and Settings

Control Panel: Program dial, Display, Start/Pause, Option buttons (Delay, Spin Speed, Temperature), Settings button.

Display Icons: Time remaining, child lock, delay start, spin speed, temperature, door locked.

Program Selection: Turn dial to desired program (e.g., Cotton, Synthetics, Delicates). Options: Adjust temperature (cold to 90°C), spin speed (0 to 1400 rpm), delay start (1-24 hrs). Settings: Press Settings button to access child lock, buzzer volume, end-of-cycle signal. Detergent Drawer: Compartment I (pre-wash), II (main wash), III (fabric softener).

Connecting Water & Drain

Water Inlet: Connect hoses to taps (blue=cold, red=hot). Drain: Place hose in standpipe (max height 100 cm).

1. Turn off taps and unplug machine before connecting.
2. Attach hoses: Screw onto taps; hand-tighten plus quarter turn with pliers.
3. Check for leaks: Turn taps on slowly; inspect connections.
4. Secure drain hose: Use hook provided; do not submerge in water.

Tip: Use new hoses; replace every 5 years.

Using Wash Programs

Supports cotton, synthetics, delicates, wool, quick wash.

1. Load laundry: Do not exceed 6 kg; distribute evenly.
2. Add detergent: Use drawer compartment II; follow dosage instructions.
3. Select program: Turn dial (e.g., Cotton for normal loads).
4. Adjust options: Press Temperature or Spin Speed buttons if needed.
5. Start: Press Start/Pause; door locks and cycle begins.
6. Pause/change: Press Start/Pause to stop; wait for door unlock signal.
7. End of cycle: Buzzer sounds; door unlocks after a few minutes.
8. Remove laundry: Leave door open to dry drum.

WARNING! Do not open door during spin; wait for unlock icon.

Special Functions

Delay Start: Press Delay button, use +/- to set hours (1-24). Child Lock: Press and hold Settings for 3 seconds to lock/unlock controls. Anti-Crease: Keeps tumbling after cycle to reduce wrinkles. Extra Rinse: Adds rinse cycle for sensitive skin.

Care & Cleaning

Unplug before cleaning. Wipe exterior with damp cloth. Clean detergent drawer monthly; remove and rinse under tap. Clean drum: Run "Drum Clean" program monthly (without laundry). Check filter: Turn off taps, unplug, open filter cover at front, drain water, clean filter.

CAUTION! Do not use abrasive cleaners; empty pockets to avoid drum damage.

Regulatory Information

CE marked; complies with EU directives for safety and electromagnetic compatibility. Energy label according to EU Regulation 2019/2014. Manufactured by Hotpoint, a brand of Whirlpool Corporation. For support, visit www.hotpoint.eu or contact local service center.

Troubleshooting

Reset: Unplug for 5 minutes, then restart.

Service: Contact authorized Hotpoint service; keep model number ready.