Hotpoint Washing Machine NWS 8469 WK SPT Manual

The Hotpoint NWS 8469 WK SPT is a freestanding washing machine with a 9 kg load capacity, 1400 rpm spin speed, energy rating A+++, and multiple wash programs including Cotton, Synthetics, Delicates, Wool, Quick Wash, and Eco cycles. It features a digital display, delay timer, child lock, anti-flood system, and imbalance detection. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: Control panel with digital display, detergent drawer, drum, door, water inlet hoses, drain hose, adjustable feet, and power cord.

Installation

Unpack and remove transit bolts. Place on level floor.

1. Remove transit bolts: Use spanner to remove 4 bolts at rear; keep for future moves.
2. Connect water supply: Attach inlet hoses to cold water tap (blue marker) and hot if available (red marker).
3. Connect drain hose: Place in standpipe or sink; secure with hook if provided.
4. Level the machine: Adjust front feet to ensure stability; check with spirit level.
5. Plug into grounded power outlet.

WARNING! Do not install in areas below 0°C. Ensure water pressure is between 0.5 and 10 bar.

First-Time Setup

Before first wash, run a maintenance cycle.

1. Power on: Plug in and press POWER button.
2. Run empty wash: Select Cotton program at 90°C without laundry.
3. Set preferences: Use OPTIONS button to set beep volume, default spin speed, etc.
4. Load detergent: Fill drawer compartments as per instructions.

CAUTION! Ensure transit bolts are removed to prevent damage. Check for leaks after connections.

Specifications

• Model: NWS 8469 WK SPT
• Capacity: 9 kg
• Spin Speed: 1400 rpm (adjustable)
• Dimensions (HxWxD): 85 x 60 x 60 cm
• Water Pressure: 0.5 - 10 bar
• Programs: 14 including Cotton, Synthetics, Delicates, Wool, Quick 30', Eco 40-60, Sport, Jeans, Anti-Allergy
• Energy Consumption: 0.95 kWh per cycle (Cotton 60°C)
• Water Consumption: 52 liters per cycle (Cotton 60°C)
• Noise Level: 53 dB (washing), 73 dB (spinning)
• Power Supply: 230-240V, 50Hz

Controls and Settings

Control Panel: POWER, START/PAUSE, PROGRAM selector knob, OPTIONS button, DELAY button, CHILD LOCK button.

Display Icons: Time remaining, spin speed, temperature, delay, child lock, door lock.

Program Selection: Turn knob to desired program (Cotton, Synthetics, etc.). Options: Press OPTIONS to adjust spin speed (0-1400 rpm), temperature (cold-90°C), extra rinse, pre-wash. Delay Timer: Press DELAY to set start time (1-24 hours). Child Lock: Press and hold CHILD LOCK for 3 seconds to activate/deactivate.

Connecting Water & Drain

Water Inlet: Connect hoses to taps (blue=cold, red=hot). Drain: Place hose in standpipe (max height 100 cm).

1. Ensure taps are off before connecting hoses.
2. Use only supplied hoses; do not reuse old ones.
3. Secure drain hose to prevent slipping.
4. Check for leaks after first connection.

Tip: Install a drip tray if machine is on wooden floor.

Using Wash Programs

Select program based on fabric type and soil level.

1. Load laundry: Do not exceed 9 kg; distribute evenly.
2. Add detergent: Use drawer compartments I (pre-wash), II (main wash), * (softener).
3. Select program: Turn knob (e.g., Cotton for cottons).
4. Set options: Adjust temperature, spin speed if needed.
5. Start: Press START/PAUSE; door locks automatically.
6. Pause/change: Press START/PAUSE to stop; wait 2 minutes to unlock door.
7. End of cycle: Signal sounds; door unlocks after a few minutes.

WARNING! Do not open door during wash; wait for unlock signal. Remove items promptly to avoid wrinkles.

Special Functions

Delay Start: Set 1-24 hours for delayed start. Child Lock: Locks controls during wash. Extra Rinse: Adds rinse cycle for sensitive skin. Pre-Wash: For heavily soiled loads. Quick 30': Fast wash for lightly soiled loads. Eco 40-60: Energy-saving program for 40-60°C washes.

Care & Cleaning

Monthly maintenance: Clean detergent drawer, door seal, and drum.

1. Detergent drawer: Remove and rinse under water.
2. Door seal: Wipe with damp cloth; remove debris.
3. Drum: Run empty Cotton program at 90°C with washing machine cleaner.
4. Filter: Clean drain pump filter every 3 months (see manual).

CAUTION! Unplug before cleaning. Do not use abrasive cleaners.

Regulatory Information

CE marked; complies with EU directives. Waste electrical products must not be disposed of with household waste. Please recycle according to local regulations. Manufacturer: Hotpoint, a Haier company. For support, visit www.hotpoint.eu or contact 0344 822 4224 (UK).

Troubleshooting

Reset: Unplug for 5 minutes, then restart.

Service: 0344 822 4224; www.hotpoint.eu