Hotpoint washing machine FDEU 9640 P UK manual

The Hotpoint FDEU 9640 P is a freestanding 9kg capacity washing machine with an A+++ energy rating, 1400 rpm spin speed, and multiple wash programs including Cotton, Synthetics, Delicates, Wool, and Quick Wash. It features a digital display, delay timer, child lock, anti-flood protection, and anti-vibration system. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Water & Drain 7. Using Wash Programs 8. Special Features 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: 9kg drum capacity, Digital display, Program selector knob, Delay timer, Child lock, Anti-flood system, Adjustable feet.

Feature	Description
Capacity	9kg maximum load
Energy Rating	A+++ (most efficient)
Spin Speed	Up to 1400 rpm
Digital Display	Shows time, cycle stage, and settings
Programs	14 programs including Eco, Quick, and Wool
Delay Timer	Up to 24 hours delay start
Child Lock	Locks controls during operation
Anti-Flood Protection	Automatic water shut-off if leak detected
Anti-Vibration System	Reduces noise and movement
Adjustable Feet	For leveling on uneven floors

Installation

Unpack and remove transit bolts. Place on solid, level floor.

Remove transit bolts: Use spanner to remove 4 bolts at rear; keep for future moves.
Connect water inlet: Attach inlet hose to cold water tap (3/4” thread).
Connect drain hose: Place in standpipe or sink (max height 100cm).
Level the machine: Adjust feet until machine is stable and does not rock.
Plug into grounded power socket.

WARNING! Do not install in areas below 0°C. Ensure transit bolts are removed before use.

First-Time Setup

Before first wash, run a maintenance cycle.

Power on: Plug in and press POWER button.
Run empty wash: Select Cotton 90°C program without detergent.
Set clock: Press and hold CLOCK button, use +/- to set time.
Load laundry: Do not exceed 9kg; separate colours and fabrics.
Add detergent: Use drawer compartments I (pre-wash), II (main wash), * (softener).

CAUTION! Overloading can cause poor wash results and damage.

Specifications

Model: FDEU 9640 P UK
Capacity: 9kg
Energy Class: A+++
Spin Speed: 1400 rpm
Water Pressure: 0.5 - 10 bar
Programs: 14 including Eco 40-60, Cotton, Synthetics, Delicates, Wool, Quick 30’
Dimensions (HxWxD): 85 x 60 x 60 cm
Power Supply: 220-240V, 50Hz
Noise Level: Wash: 53 dB, Spin: 74 dB

Controls and Settings

Control panel: POWER button, Program selector knob, Display, START/PAUSE, Delay, Options buttons.

Programs: Cotton (20°C-90°C), Synthetics (30°C-60°C), Delicates (30°C), Wool (40°C), Quick Wash (30°C), Eco 40-60, Drum Clean.

Options: Extra Rinse, Pre-wash, Anti-crease, Speed Wash, Delay Start (1-24h). Settings: Child Lock (press and hold START 3 sec), Temperature adjustment, Spin speed reduction.

Connecting Water & Drain

Water inlet: Cold fill only. Drain: To standpipe or sink.

Turn off water tap before connecting hose.
Connect inlet hose to tap; hand-tighten, then quarter turn with pliers.
Place drain hose in standpipe (max 100cm high) or over sink edge.
Ensure no kinks in hoses.

Tip: Check for leaks after first connection by running a short cycle.

Using Wash Programs

Select program based on fabric type and soil level.

Load laundry: Open door, load sorted items, close firmly.
Add detergent: Pull drawer, add to correct compartment, close gently.
Select program: Turn knob to desired program (e.g., Cotton).
Set options: Press Extra Rinse, Delay, etc. as needed.
Start: Press START/PAUSE; display shows remaining time.
Pause/change: Press START/PAUSE to stop; door locks during wash.
End of cycle: Machine beeps; wait for door lock symbol to go out.

WARNING! Do not open door during wash; hot water may cause burns.

Special Features

Child Lock: Press and hold START 3 seconds to activate/deactivate. Anti-flood: Automatic shut-off if leak detected. Drum Clean: Run monthly with detergent to prevent mould.

Care & Cleaning

Unplug before cleaning. Wipe exterior with damp cloth. Clean detergent drawer monthly; remove and rinse under tap. Clean door seal to remove lint and debris. Run Drum Clean program monthly.

CAUTION! Do not use abrasive cleaners; keep control panel dry.

Regulatory Information

Complies with UK safety standards. CE marked. Waste electrical products must not be disposed of with household waste. Please recycle according to local regulations. For support, visit www.hotpoint.co.uk or contact 03448 113 113.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Machine won't start	Door not closed/power	Close door firmly; check plug and power; ensure child lock off.
No water intake	Tap off/hose kinked	Open tap; check hose for kinks; clean inlet filter.
Excessive vibration	Transit bolts/leveling	Ensure transit bolts removed; adjust feet for level.
Water not draining	Drain hose blocked	Check hose for blockages; ensure not too high.
Error codes (e.g., F01)	Various faults	Consult manual error code list; unplug for 5 min, retry.

Reset: Unplug for 5 minutes, then restart.

Service: 03448 113 113; www.hotpoint.co.uk