Hotpoint washing machine WMAOD 743P UK manual

The Hotpoint WMAOD 743P is a freestanding 7kg capacity washing machine with an A+++ energy rating, 1400 RPM spin speed, and multiple wash programs. It features Hotpoint's Anti-Stain technology, Direct Spray pre-wash, delay timer, and child lock. Designed for UK households, it operates on 220-240V, 50Hz. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Water & Drain 7. Using Wash Programs 8. Special Functions 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: 7kg drum, LED display, control dial, detergent drawer, filter, water inlet hoses, drain hose.

FeatureDescription
Capacity7kg laundry load
Energy RatingA+++ (most efficient)
Spin SpeedUp to 1400 RPM
Anti-Stain TechnologyAutomatic stain removal for common stains
Direct SprayPre-wash spray to loosen dirt
Programs14 programs including Cotton, Synthetics, Delicates, Quick Wash
Delay TimerUp to 24 hours delay start
Child LockPrevents accidental program changes
DisplayLED with time remaining indicator
DoorReversible for left/right opening

Installation

Unpack and remove transit bolts. Place on level floor.

  1. Remove transit bolts: Use spanner to remove 4 bolts at rear; keep for future moves.
  2. Connect water supply: Attach inlet hoses to hot/cold taps (blue for cold, red for hot).
  3. Connect drain hose: Place in standpipe or sink; use U-bend hook if provided.
  4. Level the machine: Adjust front feet until machine is stable and does not rock.
  5. Plug into grounded 3-pin socket.

WARNING! Do not use extension leads. Ensure water connections are tight to prevent leaks.

First-Time Setup

Before first wash, run a maintenance cycle.

  1. Power on: Plug in and press power button.
  2. Run empty wash: Select Cotton 90°C program without laundry and run to clean drum.
  3. Set preferences: Use control dial and buttons to set default options if needed.
  4. Load detergent: Fill drawer compartments I (pre-wash), II (main wash), * (softener).

CAUTION! Ensure transit bolts are removed to prevent damage during spin.

Specifications

Controls and Settings

Control Panel: Power button, program dial, start/pause, delay timer, child lock, option buttons.

Program Dial: Turn to select program (Cotton, Synthetics, Delicates, Quick 30', etc.).

Options: Temperature selection (cold to 90°C), spin speed (0 to 1400 RPM), extra rinse, anti-crease. Display: Shows time remaining, program stage, and selected options. Child Lock: Press and hold for 3 seconds to lock/unlock controls. Delay Timer: Set start delay up to 24 hours.

Connecting Water & Drain

Water Inlet: Two hoses (hot/cold) with filters. Drain: Hose with end piece.

  1. Connect hoses to taps: Ensure washers are fitted; hand-tighten, then quarter turn with pliers.
  2. Drain hose: Insert into standpipe (max height 100 cm) or over sink edge.
  3. Check for leaks: Turn on taps and inspect connections before first use.

Tip: Use only new hoses; do not reuse old ones.

Using Wash Programs

Select program based on fabric type and soil level.

  1. Load laundry: Do not overload; distribute evenly.
  2. Add detergent: Use drawer compartments as directed.
  3. Select program: Turn dial (e.g., Cotton for towels/bedding).
  4. Set options: Adjust temperature, spin speed, extra functions.
  5. Start: Press start/pause; door locks automatically.
  6. End of cycle: Signal sounds; door unlocks after a short delay.
  7. Unload: Remove laundry promptly to avoid creasing.

WARNING! Do not open door during wash; wait until unlock symbol appears.

Special Functions

Anti-Stain: Automatically adjusts cycle for stains like wine, grass, grease. Direct Spray: Pre-wash spray to improve cleaning. Quick Wash: 30-minute cycle for lightly soiled loads. Delay Timer: Postpone start up to 24 hours. Child Lock: Locks controls to prevent tampering.

Care & Cleaning

Monthly maintenance: Clean detergent drawer, door seal, and filter.

  1. Detergent drawer: Remove and rinse under warm water.
  2. Door seal: Wipe with damp cloth to remove residue.
  3. Filter: Locate at front bottom; turn counterclockwise to remove and clean.
  4. Drum: Run hot wash cycle empty with machine cleaner or vinegar.

CAUTION! Unplug before cleaning filter. Do not use abrasive cleaners.

Regulatory Information

Complies with UK Electrical Equipment Safety Regulations 2016. CE marked. Waste electrical products must not be disposed of with household waste. Please recycle according to local regulations. For support, visit www.hotpoint.co.uk or contact 03448 113 113.

Troubleshooting

SymptomPossible CauseCorrective Action
Machine won't startPower/doorCheck plug is in; ensure door is closed properly; press start.
No water enteringTaps/hoses/filterEnsure taps are on; check hoses for kinks; clean inlet filters.
Water leakingConnections/doorTighten hose connections; check door seal for debris.
Excessive vibrationTransit bolts/levelEnsure transit bolts removed; re-level machine on floor.
Drum not spinningLoad imbalanceRedistribute laundry evenly; select lower spin speed.
Error codes (e.g., F01)Fault detectedConsult manual error code list; unplug for 5 minutes, retry.

Reset: Unplug for 5 minutes, then restart.

Service: 03448 113 113; www.hotpoint.co.uk

Hotpoint WMAOD 743P UK manual © - All Rights Reserved 2025