Hotpoint washing machine WDAL 8640G manual

The Hotpoint WDAL 8640G is a freestanding washing machine with an 8kg capacity, A+++ energy rating, 1400 rpm spin speed, and multiple wash programs including Cotton, Synthetic, Delicates, Wool, Quick Wash, and Eco cycles. Features include a digital display, delay timer, child lock, anti-crease function, and imbalance detection. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: Control panel with digital display, detergent drawer, door with safety lock, water inlet valves, drain pump filter, adjustable feet, and power cord.

Installation

Unpack and remove all transit bolts and packaging. Place on level, solid floor.

1. Remove transit bolts: Use spanner to remove 4 bolts at rear; keep for future moves.
2. Adjust feet: Turn to level machine; use spirit level to check.
3. Connect water supply: Attach inlet hoses to hot/cold taps (if applicable) and machine inlet valves.
4. Connect drain hose: Place in standpipe or secure to sink edge (max height 100 cm).
5. Plug into grounded power outlet.

WARNING! Do not install in wet areas. Ensure transit bolts are removed before use to prevent damage.

First-Time Setup

Plug in and run a maintenance wash before first use.

1. Check installation: Ensure hoses are secure and no leaks.
2. Run empty wash: Select Cotton program at 90°C without laundry to clean drum.
3. Set preferences: Use CONTROL knob and OPTIONS buttons to adjust default settings if needed.
4. Load detergent: Fill drawer compartments as per detergent instructions.

CAUTION! Use only HE (High Efficiency) detergent suitable for front loaders.

Specifications

• Type: Freestanding front loader.
• Capacity: 8 kg (dry weight).
• Dimensions (HxWxD): 85 x 60 x 60 cm.
• Energy Consumption: 150 kWh per year (standard cycle).
• Water Consumption: 52 litres per cycle (Cotton 40°C).
• Noise Level: Wash: 53 dB; Spin: 73 dB.
• Programs: Cotton, Synthetic, Delicates, Wool, Quick Wash, Eco 40-60, Sport, Jeans, etc.
• Power Supply: 220-240V, 50Hz, 10A.
• Weight: 70 kg.

Controls and Settings

Control Panel: POWER button, CONTROL knob (select program), START/PAUSE button, OPTIONS buttons (e.g., Temp, Spin, Delay).

Display Icons: Time remaining, child lock, door locked, temperature, spin speed, delay timer active.

Program Selection: Turn CONTROL knob to desired program (e.g., Cotton, Eco 40-60). Options: Adjust temperature (cold to 90°C), spin speed (0 to 1400 rpm), delay timer (1-24h). Special Functions: Child Lock (press and hold for 3 sec), Anti-Crease (reduces wrinkles), Extra Rinse (adds rinse cycle).

Connecting Water & Drain

Water Inlet: Connect hoses to hot/cold taps (if machine has dual inlet) or cold only. Drain: Secure hose to standpipe or sink.

1. Ensure taps are off before connecting hoses.
2. Use only supplied hoses; do not reuse old ones.
3. Drain hose must not be kinked or submerged.
4. After connection, open taps fully and check for leaks.

Tip: Install a drip tray if machine is on wooden floor.

Using Wash Programs

Select program based on fabric type and soil level.

1. Load laundry: Do not exceed 8 kg; distribute evenly.
2. Add detergent: Use drawer compartments I (pre-wash), II (main wash), * (softener).
3. Select program: Turn CONTROL knob (e.g., Cotton for cottons).
4. Adjust options: Press OPTIONS to set temperature, spin, delay, etc.
5. Start: Press START/PAUSE; door locks and cycle begins.
6. Pause/Stop: Press START/PAUSE to pause; turn knob to reset to stop.
7. End of cycle: Signal sounds; door unlocks after a few minutes.

WARNING! Do not open door during wash; wait for unlock signal.

Special Functions

Delay Timer: Set 1-24 hours delay start. Child Lock: Locks controls (press and hold Child Lock button). Anti-Crease: Tumbles intermittently after wash to reduce wrinkles. Extra Rinse: Adds rinse cycle for sensitive skin. Imbalance Detection: Automatically redistributes load if uneven.

Care & Cleaning

Monthly maintenance: Clean detergent drawer, door seal, and drum. Run maintenance wash (90°C Cotton program without laundry). Clean pump filter every 3 months.

CAUTION! Unplug before cleaning. Do not use abrasive cleaners on door or drum.

Regulatory Information

CE marked; complies with EU directives for safety and electromagnetic compatibility. Energy label according to EU regulation 2019/2014. Manufactured for the European market. For support, visit www.hotpoint.eu or contact local service center.

Troubleshooting

Reset: Unplug for 5 minutes to reset electronic control.

Service: Contact authorized Hotpoint service; www.hotpoint.eu