Hotpoint washing machine BI WDHG 961484 UK manual

The Hotpoint BI WDHG 961484 is a freestanding washing machine with a 9kg capacity, 1600 RPM spin speed, and energy rating A+++. It features multiple wash programmes, a digital display, delay start, child lock, and anti-flood protection. Designed for UK households, it operates on 220-240V, 50Hz. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Water & Drain 7. Using Wash Programmes 8. Special Functions 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Control panel with digital display, detergent drawer, drum, door seal, water inlet hoses, drain hose, adjustable feet, and filter.

FeatureDescription
Capacity9kg drum for large laundry loads
Spin SpeedUp to 1600 RPM for efficient drying
Energy RatingA+++ for low energy consumption
Digital DisplayShows programme time, settings, and status
Detergent DrawerCompartments for pre-wash, main wash, and softener
Programme DialSelects wash programmes (Cotton, Synthetic, etc.)
Delay StartDelays programme start up to 24 hours
Child LockLocks controls to prevent accidental changes
Anti-Flood ProtectionLeak detection system
Quick Wash30-minute programme for lightly soiled items

Installation

Unpack and remove transit bolts. Place on level floor near water and drain points.

  1. Remove transit bolts: Use spanner to remove four bolts at rear; keep for future moves.
  2. Connect water supply: Attach inlet hoses to cold water tap (blue) and hot if available (red).
  3. Connect drain hose: Place in standpipe or sink; secure with hook if provided.
  4. Level the machine: Adjust front feet using spanner; ensure machine is stable.
  5. Plug into grounded power socket.

WARNING! Do not install in wet areas. Ensure transit bolts are removed before use to prevent damage.

First-Time Setup

Power on machine; run initial empty wash.

  1. Load detergent: Add small amount to drawer compartment II.
  2. Select programme: Turn dial to "Cotton 90°C".
  3. Start: Press Start/Pause; machine will fill, heat, and complete cycle.
  4. Set preferences: Use Settings button for buzzer volume, display brightness.

CAUTION! Ensure hoses are securely connected to avoid leaks. Check for kinks in hoses.

Specifications

Controls and Settings

Control Panel: Programme dial, digital display, Start/Pause, Delay Start, Settings, Child Lock.

Display Icons: Wash, Rinse, Spin, Child Lock, Delay Start, Temperature, Spin Speed.

Programme Selection: Turn dial to desired programme (e.g., Cotton, Synthetic). Settings: Press Settings button to adjust spin speed, temperature, extra rinse, pre-wash. Delay Start: Press Delay to set start time (1-24 hours). Child Lock: Press and hold Child Lock for 3 seconds to enable/disable (default off).

Connecting Water & Drain

Water Inlet: Connect hoses to taps (blue=cold, red=hot). Drain: Place hose in standpipe (max height 100cm).

  1. Turn off taps before connecting hoses.
  2. Ensure hose washers are fitted; tighten by hand, then quarter-turn with pliers.
  3. Check for leaks after first use.

Tip: Use drain hose extension if needed; do not submerge in water.

Using Wash Programmes

Supports various fabrics and soil levels.

  1. Load laundry: Do not overload; distribute evenly.
  2. Add detergent: Use drawer compartments I (pre-wash), II (main wash), III (softener).
  3. Select programme: Turn dial (e.g., Cotton for towels/bedding).
  4. Adjust settings: Press Settings to change temperature, spin speed.
  5. Start: Press Start/Pause; display shows time remaining.
  6. Pause/Stop: Press Start/Pause to pause; turn dial to reset to stop.
  7. After wash: Remove laundry promptly; leave door ajar to dry drum.

WARNING! Do not wash items soaked in solvents; remove coins/objects from pockets.

Special Functions

Delay Start: Delays programme start for off-peak energy use. Child Lock: Locks controls during wash. Extra Rinse: Adds rinse cycle for sensitive skin. Pre-Wash: For heavily soiled loads. Rapid 30: Quick wash for lightly soiled items.

Care & Cleaning

Unplug before cleaning. Wipe exterior with damp cloth. Clean detergent drawer monthly; remove and rinse under tap. Clean door seal and glass to remove lint. Run maintenance wash every 3 months: use drum cleaner or hot cotton programme without laundry.

CAUTION! Do not use abrasive cleaners; keep control panel dry.

Regulatory Information

Complies with UK Electrical Equipment Safety Regulations. CE marked. Waste disposal: Dispose of packaging and old machine per local regulations. For support, visit www.hotpoint.co.uk or contact 03448 113 113.

Troubleshooting

SymptomPossible CauseCorrective Action
Machine not startingPower/doorCheck plug is in; ensure door is closed properly; press Start/Pause.
No water intakeTaps/hosesEnsure taps are on; check hoses for kinks; clean inlet filter.
Leaking waterHoses/doorTighten hose connections; check door seal for debris; ensure detergent drawer closed.
Excessive vibrationTransit bolts/loadEnsure transit bolts removed; level machine; redistribute laundry load.
Drum not spinningLoad imbalancePause and redistribute load; select lower spin speed.
Error codes (e.g., F01)FaultConsult manual; unplug for 5 minutes, restart; if persists, call service.

Reset: Unplug for 5 minutes, then restart.

Service: 03448 113 113; www.hotpoint.co.uk

Hotpoint washing machine BI WDHG 961484 UK manual © - All Rights Reserved 2025