Hotpoint washing machine H8 W946WB IT manual

The Hotpoint H8 W946WB IT is a freestanding washing machine with an 8 kg load capacity, featuring multiple wash programs, energy efficiency class A+++, spin speed up to 1400 rpm, delay timer, child lock, anti-flood system, and self-cleaning detergent drawer. Designed for 220-240V, 50Hz power supply. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Water Supply 7. Using Wash Programs 8. Special Functions 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Control panel with digital display, detergent drawer, drum, water inlet valves, drain pump, adjustable feet, and power cord.

Feature	Description
Capacity	8 kg maximum load
Spin Speed	Up to 1400 rpm (adjustable)
Energy Class	A+++ (most efficient)
Programs	15 programs including Cotton, Synthetic, Delicate, Quick Wash
Delay Timer	Up to 24 hours
Child Lock	Prevents accidental program changes
Anti-Flood System	Automatic water leak protection
Self-Cleaning	Detergent drawer and drum clean cycle
Display	Digital with time remaining, cycle indicators
Door	Reversible opening (left/right)

Installation

Unpack and remove transit bolts. Place on level floor.

Remove transit bolts: Use spanner to remove 4 bolts at rear; keep for future moves.
Adjust feet: Turn to level machine; use spirit level to check.
Connect water supply: Attach inlet hose to cold water tap (3/4”); ensure washers are fitted.
Connect drain hose: Place in standpipe or sink; secure with hook if provided.
Plug into grounded power outlet.

WARNING! Do not install in wet areas. Ensure transit bolts are removed before use to prevent damage.

First-Time Setup

Power on machine; run initial setup cycle.

Select language: Press and hold START/PAUSE for 3 seconds to choose language (default ITALIAN).
Run drum clean: Select “Drum Clean” program without laundry to remove factory residues.
Set water hardness: In settings menu, adjust based on local water (soft/medium/hard).
Load detergent: Fill drawer compartments as per detergent type.

CAUTION! Ensure machine is level to prevent vibration. Use two people for positioning.

Specifications

Model: H8 W946WB IT
Capacity: 8 kg (cotton)
Dimensions (HxWxD): 85 x 60 x 55 cm
Spin Speed: 1400 rpm (variable)
Energy Rating: A+++
Water Pressure: 0.5 - 10 bar
Power Supply: 220-240V, 50Hz
Programs: 15 including Eco 40-60, Wool, Sport, Jeans
Noise Level: 53 dB (wash), 73 dB (spin)
Weight: 68 kg

Controls and Settings

Control Panel: POWER button, program selector knob, START/PAUSE, OPTIONS buttons (Temp, Spin, Delay), display.

Programs: Cotton (40°C, 60°C, 90°C), Synthetic, Delicate, Wool, Quick Wash (30 min), Eco 40-60, Drum Clean, Rinse & Spin, Spin Only. Options: Temperature selection (cold to 90°C), spin speed (0-1400 rpm), delay timer (1-24h). Settings: Child lock (press and hold OPTIONS for 3 sec), buzzer on/off, water hardness.

Connecting Water Supply

Cold water fill only (unless model specifies hot). Use supplied hose.

Ensure tap is off; connect hose to machine inlet (marked “ACQUA FREDDA”).
Connect other end to tap; tighten by hand, then a quarter turn with pliers.
Open tap fully; check for leaks.
Place drain hose in standpipe (min 60 cm height) or over sink edge.

Tip: Do not kink hoses. Use only genuine Hotpoint hoses; replace every 5 years.

Using Wash Programs

Select program based on fabric type and soil level.

Load laundry: Do not exceed 8 kg; distribute evenly.
Add detergent: Use drawer compartments I (pre-wash), II (main wash), * (softener).
Select program: Turn knob to desired program (e.g., Cotton 40°C).
Adjust options: Press Temp, Spin, Delay to modify.
Start: Press START/PAUSE; display shows time remaining.
Pause/change: Press START/PAUSE to pause; turn knob to change program (if allowed).
End of cycle: Buzzer sounds; door unlocks after a few minutes.

WARNING! Do not open door during high-temperature cycles. Wait for drum to stop.

Special Functions

Delay Timer: Set 1-24 hours delay start. Child Lock: Locks controls (enable/disable by holding OPTIONS 3 sec). Anti-Crease: Tumbles intermittently after cycle to reduce wrinkles. Extra Rinse: Adds rinse cycle for sensitive skin. Speed Wash: Reduces time for lightly soiled loads.

Care & Cleaning

Monthly maintenance: Clean detergent drawer (remove and rinse). Clean drum: Run “Drum Clean” program empty at 90°C. Clean filter: Locate at front bottom; turn drain cap slowly to release water, then remove filter and clean. Wipe door seal and glass.

CAUTION! Unplug before cleaning filter. Do not use abrasive cleaners on surfaces.

Regulatory Information

CE compliant; meets EU energy labeling and ecodesign regulations. Waste electrical products must not be disposed of with household waste; recycle according to local regulations. Manufacturer: Hotpoint, a brand of Whirlpool Corporation. For support in Italy, visit www.hotpoint.it or contact 848 800 123.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Machine does not start	Power/door	Check plug, fuse; ensure door closed properly; press START/PAUSE.
No water intake	Tap/hose	Ensure tap is on; check hose for kinks; clean inlet filter.
Excessive vibration	Transit bolts/leveling	Verify transit bolts removed; adjust feet to level machine; redistribute load.
Water does not drain	Drain hose/filter	Check hose for blockages; clean pump filter; ensure standpipe height correct.
Error codes (e.g., F01)	Various faults	Consult manual error code list; unplug for 5 min, restart; if persists, call service.

Reset: Unplug for 5 minutes, then restart.

Service: 848 800 123; www.hotpoint.it