Hotpoint washing machine NSWM 843C GG UK manual

The Hotpoint NSWM 843C GG is a freestanding washing machine with an 8kg capacity, A+++ energy rating, and 1400 RPM spin speed. It features multiple wash programs, electronic controls, a digital display, delay start, child lock, and anti-flood protection. Designed for UK households, it operates on 220-240V, 50Hz. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Water & Drain 7. Using Wash Programs 8. Safety Features 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Electronic control panel, detergent drawer, door with safety lock, water inlet valves, drain pump, adjustable feet, and filter access.

Feature	Description
Capacity	8kg (dry laundry)
Energy Rating	A+++ (most efficient)
Spin Speed	Up to 1400 RPM
Programs	14 programs including Cotton, Synthetics, Delicates, Quick Wash
Display	Digital LED with time remaining
Delay Start	Up to 24 hours
Child Lock	Prevents accidental program changes
Anti-Flood	AquaStop protection system
Door Lock	Automatic during cycle
Adjustable Feet	For leveling on uneven floors

Installation

Unpack and remove all transit bolts and packaging. Place on solid, level floor.

Remove transit bolts: Use spanner to remove 4 bolts at rear; keep for future moves.
Connect water supply: Attach inlet hoses to hot/cold taps (blue=cold, red=hot).
Connect drain hose: Place in standpipe or sink (minimum height 60cm).
Level the machine: Adjust front feet until machine is stable.
Plug into grounded power outlet.

WARNING! Do not install in areas below 0°C. Ensure transit bolts are removed before first use.

First-Time Setup

Power on machine; run initial empty wash.

Set language: Press and hold START/PAUSE for 3 seconds to select English.
Load detergent: Fill drawer compartments as per detergent instructions.
Run cleaning cycle: Select "Drum Clean" program and run without laundry.
Test operation: Run a short "Quick Wash" cycle to verify connections.

CAUTION! Ensure water taps are fully open and hoses are not kinked.

Specifications

Model: NSWM 843C GG UK
Capacity: 8kg
Dimensions (HxWxD): 85cm x 60cm x 60cm
Energy Rating: A+++
Annual Energy Consumption: 150 kWh
Water Consumption: 45 litres per cycle (average)
Spin Speed: 1400 RPM (adjustable)
Programs: 14 including Eco, Wool, Sport, Anti-Allergy
Noise Level: 53 dB (washing), 75 dB (spinning)
Power Supply: 220-240V, 50Hz, 10A

Controls and Settings

Control Panel: POWER button, program selector dial, temperature button, spin speed button, option buttons, START/PAUSE, digital display.

Program Selection: Turn dial to desired program (Cotton, Synthetics, Delicates, etc.).

Temperature: Press TEMP to select (Cold, 30°C, 40°C, 60°C, 90°C). Spin Speed: Press SPIN to select (RPM: 400, 600, 800, 1000, 1200, 1400, No Spin). Options: Delay Start (1-24h), Extra Rinse, Pre-Wash, Rapid (reduced time). Display: Shows time remaining, selected options, and error codes.

Connecting Water & Drain

Water Inlet: Connect hoses to taps (max pressure 1MPa). Drain: Secure hose to standpipe or sink.

Turn off taps before connecting hoses.
Use only supplied hoses; do not extend or replace with non-approved hoses.
Ensure drain hose is not submerged to prevent siphoning.
Check for leaks after first connection.

Tip: Install a drip tray if placing on wooden floors.

Using Wash Programs

Supports various fabrics and soil levels.

Sort laundry: Separate by colour and fabric type.
Load machine: Do not exceed 8kg; distribute evenly.
Add detergent: Use drawer compartments I (pre-wash), II (main wash), * (fabric softener).
Select program: Turn dial (e.g., Cotton for towels/bedding).
Adjust settings: Set temperature, spin speed, and options.
Start: Press START/PAUSE; door locks automatically.
Pause/Stop: Press START/PAUSE to pause; press again to resume. Hold for 3 seconds to cancel.
End of cycle: Signal sounds; door unlocks after a few minutes.

WARNING! Do not open door during cycle; wait for unlock signal. Remove items promptly after cycle.

Safety Features

Child Lock: Press and hold TEMP + SPIN for 3 seconds to activate/deactivate. Door Lock: Automatic during wash. Anti-Flood: AquaStop detects leaks and shuts off water. Imbalance Control: Reduces spin speed if load is uneven.

Care & Cleaning

Unplug before maintenance. Clean detergent drawer monthly; run "Drum Clean" every 30 cycles. Check and clean filter every 3 months.

CAUTION! Do not use abrasive cleaners or high-pressure water on control panel.

Regulatory Information

Complies with UK Electrical Equipment (Safety) Regulations 2016. CE marked. Energy label according to EU Regulation 2019/2017. Manufactured for the UK market. For support, visit www.hotpoint.co.uk or contact 03448 113 113.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Machine won't start	Power/door	Check plug socket; ensure door is closed properly; press START/PAUSE.
No water intake	Taps/hoses/filter	Ensure taps are on; check hoses for kinks; clean inlet filter.
Water doesn't drain	Drain hose/filter	Check hose for blockages; clean pump filter.
Excessive vibration	Transit bolts/leveling	Ensure transit bolts removed; adjust feet to level machine; redistribute load.
Error code on display	Various faults	Consult manual error code list (e.g., F01 = water inlet fault).

Reset: Unplug for 5 minutes, then restart.

Service: 03448 113 113; www.hotpoint.co.uk