Hotpoint washing machine WDF 740 P (UK) manual

The Hotpoint WDF 740 P is a freestanding washing machine with a 7kg capacity, 1400 RPM spin speed, and an A+++ energy rating. It features multiple wash programmes, a delay timer, child lock, and AquaStop leak protection. This manual covers safety instructions, installation, programme selection, daily use, maintenance, and troubleshooting for optimal performance.

Safety Information

Read all instructions before installation and use. Keep for future reference.

WARNING! Do not install in wet areas. Ensure water and electrical connections are secure. Only use recommended detergents.

Product Overview & Features

Key components: Control panel, detergent dispenser, drum, filter, drain hose, water inlet valves, adjustable feet.

Installation Instructions

Unpack and remove all transit bolts and packaging.

1. Positioning: Place on solid, level floor near water/drain points. Allow space for door opening and ventilation.
2. Water Connection: Connect inlet hose to cold water tap (3/4” thread). Ensure washers are fitted.
3. Drain Connection: Place drain hose into standpipe or sink (max height 100cm). Secure to avoid slipping.
4. Levelling: Adjust feet using spanner so machine is stable. Check with spirit level.
5. Electrical: Plug into grounded 220-240V, 50Hz socket. Do not use extension leads.

CAUTION! Remove all transit bolts before use. Failure to do so will cause severe damage.

Control Panel & Settings

Buttons: POWER, START/PAUSE, PROGRAMME SELECTOR, TEMPERATURE, SPIN SPEED, DELAY TIMER, CHILD LOCK.

Display shows: Selected programme, time remaining, temperature, spin speed, delay time, and error codes.

Setting a wash:

1. Press POWER.
2. Turn PROGRAMME SELECTOR to desired programme.
3. Adjust TEMPERATURE and SPIN SPEED if needed.
4. Press DELAY TIMER to set start time (if required).
5. Press START/PAUSE to begin.

Child Lock: Press and hold CHILD LOCK for 3 seconds. To deactivate, repeat.

Using Your Washing Machine

1. Sorting Laundry: Separate by colour, fabric type, and soil level. Check pockets.
2. Loading: Open door, load items loosely. Do not overload beyond 7kg.
3. Detergent: Use powder/liquid for main wash in dispenser drawer compartment II. Pre-wash detergent in compartment I. Fabric softener in compartment ❤️ (max to MAX line).
4. Closing: Close door firmly until click heard.
5. Starting: Select programme and options, press START/PAUSE.
6. After Wash: Wait for door lock light to go out before opening. Remove laundry promptly.

Tip: Use correct dose of detergent based on water hardness and load size.

Wash Programmes

Note: Programmes and times may vary based on load and options selected.

Care & Maintenance

Regular maintenance ensures longevity and performance.

1. Cleaning Exterior: Wipe with damp cloth. Do not use abrasive cleaners.
2. Detergent Drawer: Pull out, rinse under tap. Clean compartment monthly.
3. Door Seal: Wipe clean after cycles to prevent mould. Leave door ajar when not in use.
4. Filter: Turn off and unplug. Open filter cover (front bottom), place bowl, unscrew filter cap slowly. Rinse filter and housing. Reassemble.
5. Drum Clean: Run empty COTTON 90°C cycle monthly with washing machine cleaner.

CAUTION! Always disconnect power before cleaning filter or interior.

Troubleshooting

Reset: Turn off at plug for 2 minutes, then restart.

Technical Specifications

• Model: Hotpoint WDF 740 P
• Capacity: 7kg
• Dimensions (HxWxD): 85cm x 60cm x 60cm
• Weight: 68kg
• Voltage/Frequency: 220-240V, 50Hz
• Power Consumption: 2000W max
• Water Pressure: 0.5 - 10 bar
• Max Spin Speed: 1400 RPM
• Energy Class: A+++
• Noise Level (wash/spin): 56/76 dB(A)

Warranty & Support

Hotpoint provides a 1-year manufacturer's warranty for parts and labour. Register your product online for extended cover options.

UK Support:

• Telephone: 03448 113 113 (Mon-Sun 8am-8pm)
• Website: www.hotpoint.co.uk/support
• Address: Hotpoint Customer Service, Peterborough, PE2 6JB

For repairs, use only authorised service agents. Keep proof of purchase.