Hotpoint Washing Machine NSWE 743U WS UK N Manual

The Hotpoint NSWE 743U WS UK N is a freestanding washing machine with a 7kg load capacity, energy rating A+++, 1400 rpm spin speed, and multiple wash programs including Cotton, Synthetic, Delicates, Wool, and Quick Wash. It features a digital display, delay start, child lock, and anti-flood protection. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: Drum, detergent dispenser, control panel, digital display, water inlet hoses, drain hose, adjustable feet.

Installation

Unpack and remove transit bolts. Place on level floor.

1. Remove transit bolts: Use spanner to remove 4 bolts at rear; keep for future moves.
2. Adjust feet: Turn to level machine; use spirit level.
3. Connect water supply: Attach inlet hoses to cold water tap (blue marker) and machine.
4. Connect drain hose: Place in standpipe or sink (max height 100 cm).
5. Plug into grounded power outlet.

WARNING! Do not install in wet areas. Ensure transit bolts are removed before use.

First-Time Setup

Plug in and run a maintenance wash.

1. Power on: Press POWER button.
2. Run initial wash: Select Cotton 90°C program without laundry to clean drum.
3. Set preferences: Use OPTIONS button to adjust spin speed, temperature, etc.
4. Test child lock: Press and hold CHILD LOCK for 3 seconds to activate.

CAUTION! Ensure water connections are tight to prevent leaks.

Specifications

• Model: NSWE 743U WS UK N
• Capacity: 7 kg
• Energy Class: A+++
• Spin Speed: 1400 rpm
• Water Pressure: 0.5 - 8 bar
• Programs: 15 (Cotton, Synthetic, Delicates, Wool, Quick Wash, etc.)
• Noise Level: 53 dB (washing), 73 dB (spinning)
• Power Supply: 230-240V, 50Hz
• Weight: 69 kg

Controls and Settings

Control Panel: POWER, PROGRAM SELECTOR, START/PAUSE, OPTIONS, DELAY START, CHILD LOCK.

Display: Shows program, time remaining, temperature, spin speed, options.

Programs: Cotton (20°C-90°C), Synthetic (30°C-60°C), Delicates (cold-30°C), Wool, Quick 30', Eco 40-60, Spin/Drain, Rinse. Options: Temperature (cold to 90°C), Spin Speed (400-1400 rpm, Rinse Hold, Extra Rinse). Delay Start: Set 1-24 hours. Child Lock: Press and hold 3 seconds.

Connecting Water & Drain

Water Inlet: Connect blue hose to cold tap. Drain: Place hose in standpipe (max 100 cm high).

1. Turn off water tap before connecting hoses.
2. Use supplied hoses; do not reuse old ones.
3. Ensure drain hose is not kinked.
4. Check for leaks after first connection.

Tip: Use hose clips for secure connections.

Using Wash Programs

Select program based on fabric type.

1. Load laundry: Do not exceed 7 kg; distribute evenly.
2. Add detergent: Use drawer compartments I (pre-wash), II (main wash), * (fabric softener).
3. Select program: Turn PROGRAM SELECTOR knob.
4. Adjust options: Press OPTIONS for temperature, spin speed, etc.
5. Start: Press START/PAUSE; display shows time remaining.
6. Pause/change: Press START/PAUSE to stop; wait 2 minutes to open door if water level is low.
7. End of cycle: Machine beeps; remove laundry promptly.

WARNING! Do not mix whites and colors. Check pockets for objects.

Special Functions

Delay Start: Set 1-24 hours for later start. Child Lock: Prevents changes during cycle. Anti-Flood: AquaStop detects leaks and stops water.

Care & Cleaning

Monthly maintenance: Clean detergent drawer, door seal, and drum.

1. Detergent drawer: Remove and rinse under water.
2. Door seal: Wipe with damp cloth; remove debris.
3. Drum: Run Cotton 90°C program without laundry.
4. Filter: Clean pump filter if draining issues occur (see manual).

CAUTION! Unplug before cleaning. Do not use abrasive cleaners.

Regulatory Information

Complies with EU directives: Low Voltage, EMC, Ecodesign, Energy Labeling. Waste disposal: Do not dispose with household waste; contact local authority. For support, visit www.hotpoint.co.uk or contact 03448 247 365.

Troubleshooting

Reset: Unplug for 5 minutes, then restart.

Service: 03448 247 365; www.hotpoint.co.uk