Hotpoint Washing Machine NR 748G WS A IT Manual

The Hotpoint NR 748G WS A IT is a 7kg capacity front-loading washing machine with energy class A+++, 1400 RPM spin speed, multiple wash programs, delay timer, child lock, and anti-flood protection. It features a digital display, rotary program selector, and is designed for built-in or freestanding installation. Below are key sections for safety, features, installation, setup, operation, maintenance, and troubleshooting.

Features at a Glance

Key components: Front-loading drum, Digital Display, Rotary Program Selector, Detergent Dispenser, Water Inlet Valves, Drain Pump Filter, Adjustable Feet, Power Cord.

Installation

Unpack and remove all transit bolts and packaging. Place on a solid, level floor.

1. Remove transit bolts: Use spanner to remove 4 bolts from rear; keep for future moves.
2. Connect water supply: Attach inlet hoses to hot/cold taps (blue=cold, red=hot). Ensure washers are fitted.
3. Connect drain hose: Place in standpipe (min 60cm height) or secure to sink edge.
4. Level the machine: Adjust front feet using a wrench; use spirit level.
5. Plug into grounded power outlet.

WARNING! Do not install in areas below 0°C. Ensure transit bolts are removed before use to prevent damage.

First-Time Setup

Before first wash, run a maintenance cycle.

1. Power on: Plug in and press POWER button.
2. Run empty wash: Select Cotton 90°C program without laundry and start to clean drum.
3. Set language: If applicable, use Settings button to select language (default English).
4. Load detergent: Fill compartments I (pre-wash), II (main wash), * (fabric softener).
5. Select program: Turn selector to desired program.

CAUTION! Ensure water connections are tight and no leaks before first use.

Specifications

• Model: NR 748G WS A IT
• Capacity: 7kg
• Dimensions (HxWxD): 85cm x 60cm x 55cm
• Energy Rating: A+++
• Annual Energy Consumption: 150 kWh
• Water Consumption: 45 liters per cycle (cotton 60°C)
• Spin Speed: 1400 RPM (adjustable)
• Noise Level: Wash 53 dB, Spin 73 dB
• Voltage/Frequency: 220-240V~, 50Hz
• Programs: 15 including Cotton, Eco, Quick, Delicates, Wool, Sport, etc.

Controls and Settings

Control Panel: POWER button, Rotary Program Selector, START/PAUSE, Delay Timer, Extra Rinse, Speed Reduction, Child Lock.

Display Icons: Door Lock, Spin, Rinse, Wash, Temperature, Time Remaining.

Program Selection: Turn knob to desired program (e.g., Cotton, Synthetics). Options: Adjust temperature (cold to 90°C), spin speed (0-1400 RPM). Special Functions: Delay Timer (1-24h), Extra Rinse, Speed Reduction, Pre-wash. Child Lock: Press and hold Child Lock button for 3 seconds to activate/deactivate.

Connecting Water & Drain

Water Inlet: Two hoses (hot/cold) with filters. Drain: Hose with U-bend or standpipe.

1. Ensure water taps are off before connecting hoses.
2. Connect hoses to machine (red to hot, blue to cold inlet).
3. Connect other ends to taps; tighten by hand then a quarter turn with pliers.
4. Place drain hose in standpipe (height 60-100cm) or secure to sink.
5. Open taps fully and check for leaks.

Tip: Use only provided hoses; do not extend or repair damaged hoses.

Using Wash Programs

Supports various fabrics and soil levels.

1. Load laundry: Do not overload; distribute evenly.
2. Add detergent: Use compartments I, II, * as needed.
3. Select program: Turn knob (e.g., Cotton for normal laundry).
4. Adjust options: Temperature, spin speed, extra functions.
5. Start: Press START/PAUSE; door locks automatically.
6. Pause/Stop: Press START/PAUSE to pause; turn knob to reset to stop.
7. End of cycle: Signal sounds; door unlocks after a few minutes.
8. Unload: Remove laundry promptly; leave door ajar to dry drum.

WARNING! Do not open door during wash/spin; wait for unlock indicator.

Special Functions

Delay Timer: Set wash to start later (1-24h). Extra Rinse: Adds rinse cycle for sensitive skin. Speed Reduction: Lowers spin speed for delicate fabrics. Pre-wash: For heavily soiled items. Child Lock: Locks controls when activated.

Care & Cleaning

Monthly maintenance recommended.

1. Clean detergent drawer: Remove and rinse under water.
2. Clean drain pump filter: Turn off and unplug; open filter cover at front bottom; place towel; drain residual water; clean filter.
3. Clean door seal: Wipe with damp cloth to remove lint/residue.
4. Run maintenance wash: Monthly, use hot cotton program without laundry or with washing machine cleaner.

CAUTION! Unplug before cleaning filter. Do not use abrasive cleaners.

Regulatory Information

CE compliant. Meets EU Ecodesign and Energy Label regulations. Waste electrical products must not be disposed of with household waste. Please recycle according to local regulations. For support, visit www.hotpoint.eu or contact Hotpoint Assistenza Clienti at 800-123-456.

Troubleshooting

Reset: Unplug for 5 minutes, then restart.

Service: 800-123-456; www.hotpoint.eu