Hotpoint washing machine WMFUG 1063P UK manual

The Hotpoint WMFUG 1063P is a freestanding front-loading washing machine with a 6kg capacity, 1400 RPM spin speed, and an A+++ energy rating. It features multiple wash programs, a delay timer, child lock, and AquaStop leak protection. This manual covers safety instructions, installation, program selection, daily use, maintenance, and troubleshooting for optimal performance.

Features at a Glance

Key components: Control panel with rotary selector and digital display, detergent dispenser, door with safety lock, water inlet hoses, drain hose, adjustable feet, and filter access.

Installation

Unpack and remove all transit bolts and packaging. Position on a solid, level floor.

1. Remove transit bolts: Use spanner to remove 4 bolts at rear; keep for future moves.
2. Adjust feet: Turn to level machine; use spirit level to check.
3. Connect water supply: Attach inlet hoses to cold water tap (blue marker) and machine inlet. Ensure washers are fitted.
4. Connect drain hose: Place into standpipe or sink (max height 100cm). Secure with provided U-bend.
5. Plug into a grounded 230V, 50Hz power socket.

WARNING! Do not install in areas below 0°C. Ensure transit bolts are removed before use to prevent damage.

First-Time Setup

Before first wash, run a maintenance cycle.

1. Power on: Plug in and press POWER button.
2. Run empty wash: Select "Drum Clean" or "Cotton 90°C" program without laundry and detergent.
3. Set preferences: Use SETTINGS button to adjust buzzer volume, end-of-cycle signal.
4. Load laundry: Do not exceed 6kg; mix large and small items for balance.
5. Add detergent: Use dispenser drawers (I: pre-wash, II: main wash, *: fabric softener).

CAUTION! Overloading can cause poor wash results and imbalance. Use only HE (High Efficiency) detergent.

Specifications

• Model: WMFUG 1063P UK
• Capacity: 6kg
• Spin Speed: 1400 RPM (adjustable)
• Energy Consumption: 0.74 kWh per cycle (Cotton 60°C)
• Water Consumption: 45 litres per cycle (Cotton 60°C)
• Noise Level: 53 dB (washing), 73 dB (spinning)
• Programs: 14 including Eco 40-60, Wool, Hand Wash, Sport, Jeans
• Dimensions: 850 x 600 x 540 mm
• Weight: 69 kg
• Power Supply: 230V~50Hz, 10A
• Water Pressure: 0.5 - 10 bar

Controls and Settings

Control Panel: POWER button, Rotary Program Selector, START/PAUSE button, Delay Timer button, Option buttons (e.g., Extra Rinse, Speed Wash), Child Lock button, Digital Display.

Program Selection: Turn knob to desired program (e.g., Cotton, Synthetic). Display shows default time, temperature, spin speed. Use Option buttons to modify (e.g., lower temperature, reduce spin).

Options: Extra Rinse, Speed Wash, Pre-Wash, Anti-Crease. Delay Timer: Press to set start delay (1-24 hours). Child Lock: Press and hold for 3 seconds to activate/deactivate (lights flash). Display: Shows time remaining, selected options, error codes (e.g., F01, F05).

Connecting Water & Drain

Water Inlet: Connect blue-coded hose to cold water supply. Drain: Hose must be placed between 60-100 cm height.

1. Ensure water tap is off before connecting hoses.
2. Check hose condition; replace if cracked.
3. Secure drain hose to prevent slipping.
4. After connection, turn on tap and check for leaks.

Tip: Use AquaStop hose (if supplied) for automatic water shut-off in case of leak.

Using Wash Programs

Select program based on fabric type and soil level.

1. Load laundry: Open door, load mixed items, close firmly.
2. Add detergent: Pull dispenser drawer, add to correct compartments.
3. Select program: Turn knob (e.g., Cotton for linens, Synthetic for blends).
4. Adjust settings: Use buttons to change temperature, spin speed, options.
5. Start: Press START/PAUSE. Door locks and cycle begins.
6. Pause/Add: Press START/PAUSE to pause; wait for door unlock symbol to add forgotten items.
7. End of cycle: Buzzer sounds; door unlocks. Remove laundry promptly to avoid creasing.

WARNING! Do not open door during high-temperature washes; wait for cool-down. Unbalance may cause machine to stop and display error.

Special Functions

Delay Timer: Delays start up to 24 hours. Child Lock: Locks control panel. Anti-Crease: Tumbles intermittently after cycle to reduce wrinkles. Drum Clean: Program for cleaning drum (run monthly).

Care & Cleaning

Regular maintenance ensures longevity.

1. Clean detergent drawer: Pull out, rinse under tap, dry and replace.
2. Clean door seal: Wipe rubber gasket to remove lint and residue.
3. Clean filter: Turn off and unplug. Open filter cover at front bottom, place towel, unscrew filter cap slowly to drain residual water, clean filter, reinsert securely.
4. Run Drum Clean monthly: Use dedicated program or 90°C cotton cycle without laundry.

CAUTION! Unplug before cleaning filter. Do not use abrasive cleaners on door or drum.

Regulatory Information

Complies with UK Electrical Equipment (Safety) Regulations 2016. CE marked. Waste electrical products should not be disposed of with household waste. Please recycle according to local regulations. For service, contact Hotpoint UK: 03448 113 113 or visit www.hotpoint.co.uk. Model WMFUG 1063P manufactured for the UK market.

Troubleshooting

Reset: Unplug for 5 minutes to reset electronic control.

Service: 03448 113 113; www.hotpoint.co.uk. Have model number and serial number ready.