Hotpoint washing machine BI WMHG 81485 UK manual

The Hotpoint BI WMHG 81485 is an 8kg capacity freestanding washing machine with an A+++ energy rating, featuring 1400 rpm spin speed, multiple wash programs including Eco 40-60, Quick Wash, and Delicates, a delay timer up to 24 hours, child lock, and anti-flood protection. This manual covers safety instructions, installation, daily use, program selection, maintenance, and troubleshooting specific to this model.

Features at a Glance

Key components: Control panel with rotary dial and digital display, detergent dispenser, drum, filter, inlet hoses, and power cord.

Installation

Unpack and remove all transit bolts and packaging. Place on a solid, level floor.

1. Position the machine: Ensure at least 1cm space from walls and cabinets.
2. Connect water supply: Attach inlet hoses to cold water tap (and hot if using dual supply). Use new hoses; do not reuse old ones.
3. Connect drain hose: Place into standpipe (min. 60cm height) or sink hook.
4. Level the machine: Adjust front feet to ensure machine is stable and does not rock.
5. Plug into a grounded 220-240V, 50Hz power outlet.

WARNING! Remove all four transit bolts at the rear before first use. Failure to do so will cause severe damage.

First-Time Setup

After installation, run an empty wash cycle to clean the drum.

1. Ensure water and power are connected.
2. Open detergent dispenser drawer and pour 100ml of bleach into compartment II (pre-wash). Close drawer.
3. Turn the program dial to "Cotton 90°C".
4. Press the Start/Pause button. The machine will run a full cycle without laundry.
5. After completion, the machine is ready for normal use.

CAUTION! Do not load laundry during the first cleaning cycle.

Specifications

• Model: BI WMHG 81485 UK
• Rated Capacity: 8 kg
• Energy Consumption (per cycle, Eco 40-60): 0.78 kWh
• Water Consumption (per cycle, Eco 40-60): 52 litres
• Spin Speed: 1400 rpm (adjustable)
• Noise Level (washing/spinning): 53/76 dB(A)
• Supply Voltage: 220-240V ~ 50Hz
• Maximum Load: 2300W
• Programs: 15
• Dimensions (HxWxD): 850 x 596 x 545 mm
• Weight: 69 kg

Controls and Settings

Control Panel: Rotary Program Dial, Digital Display, Start/Pause button, Option buttons (Delay, Extra Rinse, Pre-Wash, Anti-Crease, Speed).

Program Dial: Select from Cotton, Synthetics, Delicates, Wool, Hand Wash, Silk, Sportswear, Jeans, Daily 30', Eco 40-60, Quick 15', Drum Clean, Rinse & Spin, Spin Only, Drain.

Option Buttons: Press to activate/deactivate functions. A light indicates activation.

Display: Shows remaining time, selected options, and error codes.

Child Lock: Press and hold Delay and Extra Rinse buttons for 3 seconds to activate/deactivate.

Connecting Water & Drain

Water Inlet: Connect hoses to taps (blue for cold, red for hot if applicable). Ensure seals are tight. Drain Hose: Secure in a standpipe (60-100 cm height) or over sink edge using the U-shaped hook.

1. Turn off taps before connecting hoses.
2. Do not kink or crush hoses.
3. After connection, turn on taps fully and check for leaks.
4. Ensure drain hose is not submerged in water to prevent siphoning.

Tip: Use only the hoses supplied with the machine.

Using Wash Programs

Select program based on fabric type and soil level.

1. Load laundry: Do not exceed 8kg. Distribute items evenly.
2. Add detergent: Pour powder/liquid into the correct compartments (I: pre-wash, II: main wash, *: softener).
3. Select program: Turn dial to desired program (e.g., Cotton 40°C).
4. Select options: Press buttons for Extra Rinse, Delay, etc.
5. Start: Press Start/Pause. The door locks and cycle begins.
6. At end of cycle: "End" appears. Door unlocks after a short delay. Remove laundry promptly.

WARNING! Do not open the door during spin cycle. Wait for the door lock symbol to disappear.

Special Functions

Delay Start: Press Delay button to set start time (1-24 hours). Extra Rinse: Adds an additional rinse cycle. Pre-Wash: For heavily soiled items, uses compartment I detergent. Anti-Crease: Tumbles laundry intermittently after cycle end to reduce wrinkles. Speed: Reduces spin speed (e.g., for delicates).

Care & Cleaning

Regular maintenance ensures optimal performance.

1. Clean detergent drawer: Pull out, rinse under tap, and slide back.
2. Clean door seal: Wipe rubber gasket to remove lint and residue.
3. Clean filter: Turn off machine and water supply. Open filter cover at front bottom, place towel, unscrew filter slowly to drain residual water, clean under running water, and refit.
4. Run Drum Clean program: Every 30 washes or monthly. Use a dedicated cleaner or 100g of citric acid.

CAUTION! Unplug machine before cleaning filter. Do not use abrasive cleaners.

Regulatory Information

This appliance complies with EU Directives 2014/35/EU (LVD), 2014/30/EU (EMC), and 2009/125/EC (ErP). The symbol on the product indicates separate collection for electrical waste (WEEE). Do not dispose with household waste. For disposal, contact local authorities or retailer. For support in the UK, visit www.hotpoint.co.uk or contact 03448 113 113.

Troubleshooting

Reset: Unplug for 1 minute, then restart.

Service: 03448 113 113 (UK); www.hotpoint.co.uk