The Hotpoint Aqualtis AQ114D 69D is a freestanding washing machine with a 11kg capacity, 1400 RPM spin speed, A+++ energy rating, and multiple wash programs. It features AquaSave technology for reduced water consumption, Direct Spray for efficient detergent distribution, Anti-Stain system for tough stains, and Anti-Crease function. Below are key sections for safety, features, installation, setup, operation, maintenance, and troubleshooting.
Key components: Control panel with rotary selector and digital display, detergent drawer, drum, water inlet hoses, drain hose, adjustable feet, and power cord.
| Feature | Description |
|---|---|
| Capacity | 11kg for large laundry loads |
| Spin Speed | Up to 1400 RPM for efficient drying |
| Energy Rating | A+++ for low energy consumption |
| AquaSave Technology | Reduces water usage per cycle |
| Direct Spray System | Sprays water directly onto laundry for better detergent distribution |
| Anti-Stain System | Special programs for removing tough stains |
| Anti-Crease Function | Reduces wrinkles at end of cycle |
| Delay Start | Program start up to 24 hours later |
| Child Lock | Prevents accidental program changes |
| Quick Wash | 30-minute cycle for lightly soiled items |
Unpack and inspect contents. Place on level, solid floor.
WARNING! Do not install in wet areas. Ensure water connections are tight to prevent leaks.
Before first use, run a maintenance wash.
CAUTION! Remove all packaging materials and transit bolts before use.
Control Panel: Rotary selector for programs, digital display, temperature button, spin speed button, option buttons (Delay Start, Extra Rinse, etc.), and Start/Pause button.
Program Selection: Turn knob to desired program (Cotton, Synthetic, Delicate, Wool, etc.).
Temperature: Press TEMP button to select (cold to 90°C). Spin Speed: Press SPIN button to select (0 to 1400 RPM). Options: Delay Start (1-24h), Extra Rinse, Anti-Crease, Pre-Wash. Display: Shows time remaining, cycle stage, and selected options. Child Lock: Press and hold Delay Start and Extra Rinse for 3 seconds.
Water: Cold fill only (hose provided). Drain: Hose to standpipe or sink. Power: Grounded outlet.
Tip: Use hose clips if provided; ensure drain hose is not kinked.
Supports various fabrics and soil levels.
WARNING! Do not wash items contaminated with flammable substances. Close door after use.
Delay Start: Set 1-24 hours; press Delay Start button, use +/- to set time. Extra Rinse: Adds rinse cycle for sensitive skin. Anti-Crease: Tumbles periodically after cycle end. Pre-Wash: For heavily soiled items; add detergent to compartment I. Anti-Stain: Select specific program for stains (e.g., wine, grass).
Unplug before cleaning. Wipe exterior with damp cloth; clean detergent drawer monthly; run maintenance wash every 30 cycles.
CAUTION! Do not use abrasive cleaners; keep control panel dry.
CE marked; complies with EU directives for safety and EMC. Energy label according to EU regulation 2019/2014. Manufactured by Hotpoint, a brand of Whirlpool Corporation. For support, visit www.hotpoint.eu or contact local service center. Serial number located on door frame or rear panel.
| Symptom | Possible Cause | Corrective Action |
|---|---|---|
| Machine does not start | Power/door | Check plug; ensure door closed properly; press Start. |
| No water intake | Taps/hoses/filter | Ensure taps on; check hoses for kinks; clean inlet filter. |
| Water does not drain | Drain hose/filter | Check hose for kinks/blockage; clean pump filter. |
| Excessive vibration/noise | Transit bolts/load/leveling | Remove transit bolts; redistribute load; level machine. |
| Leaking water | Hoses/detergent drawer | Tighten hose connections; ensure drawer closed; check seal. |
| Poor wash results | Detergent/load/program | Use correct detergent amount; do not overload; select suitable program. |
| Error codes on display | Various faults | Refer to manual code list; unplug for 5 minutes, retry. |
Reset: Unplug for 5 minutes, then restart.
Service: Contact authorized Hotpoint service; have model and serial numbers ready.