Hotpoint washing machine NDD 11725 DA EE manual

The Hotpoint NDD 11725 DA EE is a freestanding washing machine with a 7 kg load capacity, energy efficiency class A+++, 1200 rpm spin speed, and multiple wash programs including Cotton, Synthetics, Delicates, Wool, and Quick Wash. It features a digital display, delay timer, child lock, anti-flood system, and imbalance control. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Water & Drain 7. Using Wash Programs 8. Special Functions 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Control panel with digital display, detergent drawer, drum, door, water inlet valves, drain pump, and adjustable feet.

FeatureDescription
Capacity7 kg (dry laundry)
Energy ClassA+++ (most efficient)
Spin SpeedUp to 1200 rpm
Programs15 programs including Cotton, Eco, Quick 30'
DisplayDigital LED with time remaining
Delay TimerUp to 24 hours
Child LockPrevents accidental program changes
Anti-FloodAquaStop protection system
Imbalance ControlReduces vibration during spin
Door LockAutomatic safety lock during operation

Installation

Unpack and remove transit bolts. Place on level floor.

  1. Remove transit bolts: Use spanner to remove 4 bolts at rear; keep for future moves.
  2. Adjust feet: Turn feet to level machine; use spirit level.
  3. Connect water supply: Attach inlet hoses to cold water tap (blue mark) and hot if available (red mark).
  4. Connect drain hose: Place in standpipe or sink edge; secure with U-bend.
  5. Plug into grounded power outlet.

WARNING! Do not install in areas below 0°C. Ensure water pressure is between 0.5 and 10 bar.

First-Time Setup

Plug in and run initial empty wash.

  1. Open water taps fully.
  2. Add detergent: Pour 100 ml of liquid detergent into drawer compartment II.
  3. Select program: Turn knob to "Cotton 90°C".
  4. Start: Press Start/Pause; machine will run empty cycle to clean drum.
  5. Set language: Press and hold Delay + Spin for 5 sec to select display language.

CAUTION! Never use machine without removing transit bolts—risk of severe damage.

Specifications

Controls and Settings

Control Panel: Program knob, digital display, temperature button, spin speed button, delay button, start/pause, option buttons.

Program Knob: Select from 15 programs. Temperature: Adjust from cold to 90°C. Spin Speed: Adjust from 0 (no spin) to 1200 rpm. Delay Timer: Set start delay up to 24 hours. Options: Extra Rinse, Pre-wash, Easy Iron. Child Lock: Press and hold Temperature + Spin for 3 sec.

Connecting Water & Drain

Water Inlet: Two hoses (blue=cold, red=hot). Drain: Hose to standpipe or sink.

  1. Ensure taps are off before connecting hoses.
  2. Connect hoses to machine first, then to taps.
  3. Drain hose height: 60-100 cm from floor.
  4. Check for leaks after first connection.

Tip: Use only supplied hoses; do not extend or repair damaged hoses.

Using Wash Programs

Select program based on fabric type.

  1. Load laundry: Do not exceed 7 kg; distribute evenly.
  2. Add detergent: Use compartment I for pre-wash, II for main wash, * for softener.
  3. Select program: Turn knob (e.g., Cotton for cottons).
  4. Adjust settings: Temperature, spin speed, options if needed.
  5. Start: Press Start/Pause; door locks automatically.
  6. End: Signal sounds; door unlocks after 2 minutes.

WARNING! Do not open door during wash—hot water risk. Wait for unlock signal.

Special Functions

Delay Timer: Set delayed start up to 24 hours. Child Lock: Locks controls during operation. Anti-Crease: Tumbles periodically after end of cycle if not unloaded. Quick 30': Fast wash for lightly soiled loads. Extra Rinse: Adds rinse cycle for sensitive skin.

Care & Cleaning

Monthly maintenance: Clean detergent drawer, door seal, and filter.

  1. Detergent drawer: Pull out, rinse under tap.
  2. Door seal: Wipe with damp cloth; remove debris.
  3. Filter: Turn drain pump cover anti-clockwise, remove filter, clean.
  4. Run "Drum Clean" program monthly with washing machine cleaner.

CAUTION! Unplug before cleaning. Do not use abrasive cleaners.

Regulatory Information

CE compliant. Meets EU Ecodesign and Energy Label regulations. Waste disposal: Follow local regulations for recycling. For support, visit www.hotpoint.eu or contact Hotpoint Assistenza Clienti at +39 0434 397051.

Troubleshooting

SymptomPossible CauseCorrective Action
Machine does not startDoor not closed/powerClose door firmly; check plug and power; ensure child lock off.
No water intakeTaps off/hose kinkedOpen taps; check hose for kinks; clean inlet filter.
Water does not drainDrain blocked/filterCheck drain hose for blockages; clean pump filter.
Excessive vibrationTransit bolts/levelingEnsure transit bolts removed; re-level feet; redistribute load.
Error code on displayFault detectedConsult manual error code list; unplug for 5 min, restart.

Reset: Unplug for 5 minutes, then restart.

Service: +39 0434 397051; www.hotpoint.eu

Hotpoint washing machine NDD 11725 DA EE manual © - All Rights Reserved 2025