Hotpoint Washing Machine WMFUG 842K UK Manual

The Hotpoint WMFUG 842K is a freestanding washing machine with an 8kg capacity, 1400 RPM spin speed, A+++ energy rating, and multiple wash programs. It features Hotpoint's AquaCare™ technology for reduced water usage, Anti-Stain™ system for tough stains, Direct Spray for even detergent distribution, and a Delay Timer. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: Control panel with rotary dial and digital display, detergent drawer, drum, filter, water inlet hoses, drain hose, adjustable feet.

Installation

Unpack and remove all transit bolts and packaging. Place on a solid, level floor.

1. Connect water supply: Attach inlet hoses to cold water tap (and hot if applicable). Ensure washers are fitted.
2. Connect drain hose: Place into standpipe (min height 60cm, max 100cm) or secure over sink edge.
3. Level the machine: Adjust the feet using a spanner until the machine is stable and does not rock.
4. Plug into a grounded 220-240V, 50Hz AC power outlet.

WARNING! Do not remove transit bolts before moving into final position. Ensure water connections are tight to prevent leaks.

First-Time Setup

Before first use, run a cotton cycle at 90°C without laundry to clean the drum.

1. Remove transit bolts: Use spanner to remove the four bolts at the rear. Keep bolts for future moves.
2. Connect hoses: Follow installation steps for water and drain.
3. Power on: Plug in and press the power button. The display will light up.
4. Select language: Use the Settings button to set display language (English default).
5. Run initial clean cycle: Add a small amount of detergent and run the 90°C cotton program.

CAUTION! Ensure the machine is perfectly level to prevent excessive vibration and noise during spin.

Specifications

• Model: WMFUG 842K UK
• Type: Freestanding Front Loader
• Capacity: 8kg (cotton)
• Max Spin Speed: 1400 RPM
• Energy Rating: A+++
• Annual Energy Consumption: 150 kWh
• Water Consumption: 52 litres per cycle (cotton 60°C)
• Noise Level (Wash/Spin): 53 dB / 75 dB
• Dimensions (HxWxD): 85 x 60 x 60 cm
• Weight: 70 kg
• Supply Voltage: 220-240V ~ 50Hz
• Programs: 16 programs including Cotton, Synthetics, Delicates, Wool, Quick Wash, Anti-Stain

Controls and Settings

Control Panel: Rotary dial (select program), Digital Display (shows time, options, errors), Touch buttons (Start/Pause, Delay, Spin Speed, Temperature, Extra Rinse, etc.).

Program Selection: Turn dial to desired program (e.g., Cotton, Synthetics, Delicates).

Adjustable Settings: After selecting a program, you can adjust: - Temperature (Cold to 90°C) - Spin Speed (RPM: 400, 600, 800, 1000, 1200, 1400, Rinse Hold, No Spin) - Extra Options: Pre-wash, Extra Rinse, Delay Start (1-24 hrs), Speed Wash (if available on program)

Child Lock: Press and hold Delay and Spin Speed buttons for 3 seconds to lock/unlock controls.

Connecting Water & Drain

Water Inlet: Use supplied hoses. Connect to cold water tap (and hot if machine is dual-fill). Ensure tap is fully open.

1. Turn off water supply and unplug machine before connecting hoses.
2. Screw hoses onto taps and machine inlet valves hand-tight, then a quarter turn with pliers.
3. Drain hose: Insert into standpipe (diameter 4-6 cm) or hook over sink edge using the U-bend holder.
4. Check for leaks: Run a short rinse cycle and inspect connections.

Tip: Do not kink or bend hoses. Ensure drain hose is not submerged in water.

Using Wash Programs

Supports various fabrics and soil levels.

1. Load laundry: Open door, load items loosely without overfilling. Close door firmly.
2. Add detergent: Pull out detergent drawer. Add powder/liquid to main wash compartment (II). For pre-wash, use compartment I. Add softener to compartment (*). Close drawer.
3. Select program: Turn dial (e.g., Cotton for towels/bedding, Synthetics for shirts, Delicates for silk).
4. Adjust settings: Press Temperature, Spin Speed, etc. to modify as needed.
5. Start: Press Start/Pause. The display shows remaining time. The door locks.
6. At end of cycle: "End" appears. Door remains locked for a few minutes. Unlock symbol appears when safe to open.
7. Remove laundry promptly to avoid creasing.

WARNING! Do not open door during wash or spin. Wait for unlock symbol. Check pockets for coins/objects.

Care & Maintenance

Regular cleaning ensures performance and longevity.

• Detergent Drawer: Pull out fully, press release clip, wash under warm water.
• Drum: Run a hot cotton cycle monthly with a drum cleaner or 1/2 cup of bicarbonate of soda.
• Filter: Locate behind the small kickplate at bottom front. Place towel, turn filter anti-clockwise to remove, clean under tap. Reinsert and tighten.
• Door Seal: Wipe clean and dry after cycles to prevent mould.
• Exterior: Wipe with a damp cloth. Do not use abrasive cleaners.

CAUTION! Unplug before cleaning. Do not use steam cleaners.

Regulatory Information

This appliance complies with EU Directives 2014/35/EU (Low Voltage), 2014/30/EU (EMC), and 2009/125/EC (Ecodesign). Waste electrical products must not be disposed of with household waste. Please recycle where facilities exist. Check with your local authority for recycling advice. Manufactured for Hotpoint, a Haier company. For support, visit www.hotpoint.co.uk or contact 0333 305 2265.

Troubleshooting

Reset: Unplug machine for 5 minutes, then restart.

Service: 0333 305 2265; www.hotpoint.co.uk. Have model number (WMFUG 842K) and serial number ready.