Hotpoint washing machine WDAL 8640G UK manual

The Hotpoint WDAL 8640G is a freestanding 8kg capacity washing machine with an A+++ energy rating, featuring 1600 RPM spin speed, AquaCare™ technology for garment care, Anti-Stain™ programs, Direct Spray for detergent efficiency, and a large LED display with dial control. It includes multiple wash programs for cotton, synthetics, delicates, and quick washes, along with delay start, child lock, and imbalance control. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: 8kg drum, LED display, Program dial, Detergent drawer, Door with safety lock, Water inlet hoses, Drain hose, Adjustable feet, Power cord.

Installation

Unpack and remove all transit bolts and packaging. Place on a solid, level floor.

1. Connect water supply: Attach inlet hoses to cold water tap (and hot if applicable). Ensure washers are fitted.
2. Connect drain hose: Place into standpipe or sink, secure with provided U-bend.
3. Level the machine: Adjust the four feet using a spanner until the machine is stable.
4. Plug into a grounded 220-240V AC, 50Hz power outlet.

WARNING! Do not remove transit bolts before moving to final location. Ensure water connections are tight to prevent leaks.

First-Time Setup

Before first use, run a cotton cycle at 90°C without laundry to clean the drum.

1. Load detergent: Pull out detergent drawer, add powder/liquid to appropriate compartments.
2. Select program: Turn dial to desired program (e.g., Cotton 60°C).
3. Set options: Press buttons for Extra Rinse, Delay Start, etc., as needed.
4. Start cycle: Press Start/Pause button. The door will lock and cycle begins.

CAUTION! Ensure the door is properly closed before starting. Overloading can cause poor wash results and imbalance.

Specifications

• Model: WDAL 8640G UK
• Capacity: 8kg
• Energy Class: A+++
• Spin Speed: 1600 RPM (adjustable)
• Water Pressure: 0.5 - 8 bar
• Programs: Cotton, Synthetics, Delicates, Wool, Quick Wash (14 min), Anti-Stain, Sportswear, etc.
• Dimensions (HxWxD): 850 x 600 x 600 mm
• Power Supply: 220-240V AC, 50Hz
• Noise Level: Wash: 53 dB, Spin: 74 dB

Controls and Settings

Control Panel: Program Dial, Start/Pause button, Option buttons (Delay, Extra Rinse, etc.), LED display.

Program Dial: Turn to select: Cotton (various temps), Easy Care, Delicates, Wool, Quick Wash, Anti-Stain, Rinse & Spin, Drain.

Options: Delay Start (1-24h), Extra Rinse, Reduced Creases, Speed Wash. Display: Shows time remaining, cycle stage, selected options. Settings: Can adjust default spin speed and temperature for some programs via pressing buttons for 3 seconds.

Connecting Water & Drain

Water Inlet: Connect hoses to taps (blue for cold, red for hot if used). Drain: Hose into standpipe (max height 100 cm) or over sink edge.

1. Ensure taps are off before connecting hoses.
2. Use only supplied hoses; do not reuse old ones.
3. Secure drain hose to prevent slipping out.
4. After connection, open taps fully and check for leaks.

Tip: Use the drain hose support if draining into a sink.

Using Wash Programs

Select program based on fabric type and soil level.

1. Load laundry: Do not exceed 8kg. Mix large and small items for balance.
2. Add detergent: Use drawer compartments I (pre-wash), II (main wash), * (fabric softener).
3. Select program: Turn dial (e.g., Cotton 40°C for everyday loads).
4. Adjust options: Press buttons for Extra Rinse, Delay, etc.
5. Start: Press Start/Pause. The door locks and cycle begins.
6. At end: "End" appears. Door unlocks after a short delay. Remove laundry promptly.

WARNING! Do not open door during cycle (hot water risk). Wait for door lock symbol to go off.

Special Functions

Delay Start: Set 1-24 hours delay. Child Lock: Press and hold Delay and Extra Rinse for 3 seconds to lock/unlock controls. Anti-Stain: Select specific stain type (wine, grass, etc.) for targeted removal. Imbalance Control: Automatically redistributes load if uneven.

Care & Cleaning

Regularly clean detergent drawer, door seal, and drum.

1. Detergent drawer: Pull out, rinse under tap, dry, and reinsert.
2. Door seal: Wipe with damp cloth to remove lint and residue.
3. Drum: Run a hot cotton cycle (90°C) monthly without laundry to prevent odors.
4. Filter: Clean pump filter periodically (see troubleshooting).

CAUTION! Unplug machine before cleaning. Do not use abrasive cleaners.

Regulatory Information

Complies with UK Electrical Equipment (Safety) Regulations 2016 and EC Directives. Waste Electrical products must not be disposed of with household waste. Please recycle according to local regulations. For support, visit www.hotpoint.co.uk or contact 03448 113 113. Hotpoint is a trademark of Whirlpool Corporation.

Troubleshooting

Reset: Unplug for 2 minutes to reset electronic control.

Service: 03448 113 113; www.hotpoint.co.uk