The Hotpoint Aqualtis AQ113D 69 is a freestanding washing machine with a 13 kg load capacity, A+++ energy rating, and 1400 rpm spin speed. It features Hotpoint's AquaSave technology for reduced water consumption, multiple wash programs including Cotton, Synthetics, Delicates, and Quick Wash, a delay timer, child lock, and anti-flood protection. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.
Key components: Control panel with rotary selector and digital display, detergent dispenser, drum, water inlet valves, drain pump, and adjustable feet.
| Feature | Description |
|---|---|
| Capacity | 13 kg maximum load |
| Energy Rating | A+++ (most efficient) |
| Spin Speed | Up to 1400 rpm |
| AquaSave Technology | Reduces water consumption per cycle |
| Programs | 16 programs including Cotton, Eco, Quick 30' |
| Delay Timer | Up to 24 hours |
| Child Lock | Locks control panel during operation |
| Anti-Flood Protection | Leak detection system |
| Display | Digital with time remaining and status icons |
| Door | Reversible for left/right opening |
Unpack and remove transit bolts. Place on level floor.
WARNING! Do not install in areas below 0°C. Ensure transit bolts are removed before use.
Plug in and run a maintenance wash.
CAUTION! Ensure machine is level to prevent vibration and noise.
Control Panel: Rotary selector, START/PAUSE button, option buttons (Delay, Extra Rinse, etc.), digital display.
Program Selection: Turn knob to desired program (Cotton, Eco 40-60, Synthetics, Delicates, Quick 30', etc.).
Options: Delay Start (1-24h), Extra Rinse, Anti-Crease, Speed Perfect (reduces time), Pre-Wash for heavily soiled loads. Display: Shows time remaining, cycle phase, and selected options. Settings Menu: Access by pressing specific combination to set water hardness, acoustic signals, end-of-cycle beep.
Water Inlet: Connect hoses to taps (blue for cold, red for hot if dual). Drain: Hose to standpipe (max height 100 cm) or sink.
Tip: Install a drip tray if machine is on wooden floor.
Select program based on fabric type and soil level.
WARNING! Do not open door during high-temperature washes; wait for cool-down.
Delay Start: Set 1-24 hours delay. Child Lock: Press and hold buttons to lock controls. Anti-Flood: Machine stops if leak detected. Drum Clean: Run monthly with dedicated program or 90°C cotton cycle without laundry.
Unplug before maintenance. Clean detergent dispenser monthly; wipe door seal and glass; run Drum Clean program regularly.
CAUTION! Do not use abrasive cleaners; keep area dry.
Complies with EU directives: Low Voltage, EMC, Ecodesign, Energy Labeling. Waste disposal: Dispose according to local regulations. Manufacturer: Hotpoint, a brand of Whirlpool Corporation. For support, visit www.hotpoint.eu or contact local service center.
| Symptom | Possible Cause | Corrective Action |
|---|---|---|
| Machine won't start | Door not closed/power | Close door firmly; check plug and power; press START/PAUSE. |
| No water intake | Taps off/hose kinked | Open taps; straighten hoses; check water pressure. |
| Excessive vibration | Transit bolts/leveling | Ensure transit bolts removed; re-level machine; redistribute load. |
| Water not draining | Drain filter/drain hose | Clean drain filter; check hose for blockages/kinks. |
| Error codes (e.g., F01, F02) | Faults | Consult manual; unplug for 5 min; if persists, call service. |
Reset: Unplug for 5 minutes to reset electronic control.
Service: Authorized Hotpoint service centers; check website for contacts.