Hotpoint washing machine H8 W946WB UK manual

The Hotpoint H8 W946WB is a freestanding washing machine with an 8kg capacity, A+++ energy rating, and 1400 RPM spin speed. It features multiple wash programmes, a delay timer, child lock, and AquaStop leak protection. Designed for UK households, it operates on 220-240V, 50Hz. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: Control panel with rotary dial and digital display, detergent drawer, drum, water inlet hoses, drain hose, and adjustable feet.

Installation

Unpack and remove all transit bolts and packaging. Place on a solid, level floor.

1. Position the machine: Ensure at least 50mm clearance at rear and sides for ventilation.
2. Connect water supply: Attach inlet hoses to cold water tap (and hot if required).
3. Connect drain hose: Place in standpipe, sink, or drain as per instructions.
4. Level the machine: Adjust the feet using a spanner until stable.
5. Remove transit bolts: Keep for future transport.
6. Plug into a grounded 3-pin socket.

WARNING! Do not install in areas prone to freezing. Ensure water connections are tight to prevent leaks.

First-Time Setup

Before first use, run a maintenance wash to clean the drum.

1. Ensure machine is installed correctly and plugged in.
2. Turn on the water supply taps fully.
3. Open the detergent drawer and add a small amount of detergent (no clothes).
4. Select the "Drum Clean" programme or a 90° Cotton programme.
5. Press Start/Pause to begin.
6. After completion, the machine is ready for normal use.

CAUTION! Always use the correct type and amount of detergent as specified.

Specifications

• Model: Hotpoint H8 W946WB
• Capacity: 8 kg
• Energy Rating: A+++
• Spin Speed: 1400 RPM
• Water Pressure: 0.5 - 8 bar
• Programmes: 15 including Eco, Cotton, Synthetics, Delicates, Wool, Quick Wash (14 mins), Sportswear, Jeans, Anti-Allergy, Drum Clean
• Noise Level (wash/spin): 53/76 dB(A)
• Power Supply: 220-240V, 50Hz
• Dimensions (HxWxD): 850 x 595 x 545 mm
• Weight: 69 kg

Controls and Settings

Control Panel: Rotary dial for programme selection, digital display, and touch buttons.

Buttons: Start/Pause, Delay Timer, Spin Speed, Temperature, Extra Rinse, Pre-Wash, Child Lock.

Programme Selection: Turn dial to desired programme (e.g., Cotton, Synthetics). Display shows default time, temperature, and spin speed. Adjustments: Use respective buttons to modify temperature (cold to 90°C), spin speed (0 to 1400 RPM), and add options like Extra Rinse. Delay Timer: Set start delay from 1 to 24 hours. Child Lock: Press and hold Child Lock button for 3 seconds to activate/deactivate.

Connecting Utilities

Water: Connect inlet hoses to cold (and hot) taps. Drain: Place hose in standpipe (max height 100cm) or sink. Power: Plug into a dedicated 13A socket.

1. Ensure all taps are off before connecting hoses.
2. Use only the supplied hoses; do not reuse old ones.
3. Secure drain hose to prevent slipping.
4. Do not use extension leads or adapters.

Tip: Check for leaks at connections after first use.

Using Wash Programmes

Follow load guidelines: Do not exceed 8kg.

1. Sort laundry by colour and fabric type.
2. Load clothes evenly into the drum; do not overload.
3. Add detergent and fabric softener to the correct compartments of the drawer.
4. Close the door firmly.
5. Select programme using rotary dial.
6. Adjust temperature, spin speed, and options as needed.
7. Press Start/Pause to begin. Display shows time remaining.
8. At end of cycle, a tone sounds. Remove laundry promptly.
9. Leave door slightly ajar after use to ventilate drum.

WARNING! Do not open door during high-temperature washes. Check pockets for objects.

Safety Features

Child Lock: Locks control panel. Door Lock: Automatically locks during wash. AquaStop: Monitors water flow; shuts off if leak detected. Overload Protection: Reduces spin speed if load is unbalanced.

Care & Cleaning

Regular maintenance ensures longevity.

1. Clean detergent drawer monthly: Remove and rinse under tap.
2. Clean door seal: Wipe to remove lint and residue.
3. Run Drum Clean programme every 30 washes or use proprietary cleaner.
4. Clean filter: Locate behind bottom panel; turn off water and power first.
5. Exterior: Wipe with damp cloth; do not use abrasive cleaners.

CAUTION! Unplug before cleaning. Never hose down the appliance.

Regulatory Information

Complies with UK Electrical Equipment (Safety) Regulations 2016, Electromagnetic Compatibility Regulations 2016. CE marked. Manufactured for the UK market. Hotpoint is a trademark of Haier Europe. For support, visit www.hotpoint.co.uk or contact 03448 113 113.

Troubleshooting

Reset: Unplug for 2 minutes, then reconnect. For persistent issues, call support.

Service: 03448 113 113; www.hotpoint.co.uk