Hotpoint washing machine WMSD 723B EU manual

The Hotpoint WMSD 723B EU is a freestanding 7kg washing machine with an A+++ energy rating, 1400 RPM spin speed, and multiple wash programs. It features a digital display, delay timer, child lock, anti-crease function, and is designed for household use. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: Digital control panel, detergent dispenser, drum, filter, water inlet hoses, drain hose, adjustable feet.

Installation

Unpack and inspect contents. Place on a solid, level floor.

1. Remove transit bolts: Use spanner to remove bolts and plugs from rear; keep for future moves.
2. Adjust feet: Turn feet to level the machine; ensure it does not rock.
3. Connect water supply: Attach inlet hoses to cold water tap (and hot if applicable) and machine inlet valves.
4. Connect drain hose: Place hose into standpipe or sink; secure with hook if provided.
5. Plug into grounded power outlet.

WARNING! Do not install in areas prone to freezing or extreme heat. Ensure water connections are tight to prevent leaks.

First-Time Setup

Before first wash, run a maintenance cycle.

1. Power on machine: Plug in and press power button.
2. Run empty drum clean: Select the "Drum Clean" program (if available) or a 90°C cotton cycle without laundry.
3. Set language: If applicable, use settings button to select language.
4. Load laundry: Do not exceed 7kg maximum load.
5. Add detergent: Use dispenser drawer compartments as instructed.
6. Select program: Turn dial to desired program.
7. Start cycle: Press Start/Pause.

CAUTION! Remove all packaging materials and transit bolts before use.

Specifications

• Capacity: 7 kg.
• Energy Rating: A+++.
• Spin Speed: Up to 1400 RPM.
• Water Pressure: 0.5 - 8 bar.
• Programs: Cotton, Synthetics, Delicates, Wool, Quick Wash, Drum Clean, etc.
• Dimensions (HxWxD): 85 x 60 x 60 cm (approx).
• Power Supply: 220-240V, 50Hz.
• Noise Level: Washing: 56 dB; Spinning: 76 dB.
• Weight: Approx. 70 kg.

Controls and Settings

Control Panel: Power button, Program Dial, Display, Start/Pause, Delay Timer, Child Lock, Option buttons (Extra Rinse, Speed Reduction).

Program Selection: Turn dial to symbol (Cotton, Synthetics, Delicates, Wool, Quick 30', etc.). Display shows estimated time, temperature, spin speed.

Temperature Selection: Press Temp button to cycle through options (Cold, 30°C, 40°C, 60°C, 90°C).

Spin Speed Selection: Press Spin button to adjust (RPM: 400, 600, 800, 1000, 1200, 1400, or No Spin).

Options: Extra Rinse, Pre-Wash, Anti-Crease, Delay Start (1-24h). Press corresponding button to activate/deactivate.

Connecting Water & Drain

Water Inlet: Connect hoses to cold (mandatory) and hot (optional) taps. Use new hoses; do not reuse old ones.

1. Turn off water taps.
2. Screw hoses onto taps and machine inlets (blue for cold, red for hot). Hand-tighten plus a quarter turn with pliers.
3. Drain hose: Place into standpipe (min. 60 cm height, max. 100 cm) or over sink edge. Secure to prevent slipping.
4. Check for leaks: Turn on taps and inspect connections before first use.

Tip: Ensure inlet filters are clean and drain hose is not kinked.

Using Wash Programs

Select program based on fabric type and soil level.

1. Load laundry: Open door, load items loosely without overfilling.
2. Add detergent: Pull dispenser drawer; add powder/liquid to correct compartments (I: pre-wash, II: main wash, *: softener).
3. Close door firmly.
4. Select program: Turn dial (e.g., Cotton for towels/bed linen).
5. Adjust settings: Use Temp, Spin, and Option buttons as needed.
6. Start: Press Start/Pause. Display shows remaining time.
7. End of cycle: Machine beeps; door unlocks after a short delay. Remove laundry promptly.

WARNING! Do not open door during high-temperature washes; steam may cause burns.

Special Functions

Delay Timer: Press Delay button repeatedly to set start time (1-24h). Child Lock: Press and hold Child Lock button for 3 seconds to lock/unlock controls. Anti-Crease: Activates tumbling at end of cycle to reduce wrinkles. Drum Clean: Run monthly with detergent to prevent odors.

Care & Cleaning

Unplug before cleaning. Wipe exterior with damp cloth. Clean detergent drawer monthly: Pull out, rinse under tap. Clean filter: Locate behind lower panel; turn counterclockwise to remove; clear debris. Clean door seal: Wipe rubber gasket to remove lint/residue.

CAUTION! Do not use abrasive cleaners or solvents. Keep ventilation openings clear.

Regulatory Information

CE Marking: Complies with EU directives. Waste Electrical and Electronic Equipment (WEEE): Do not dispose with household waste; recycle appropriately. Manufacturer: Hotpoint, a brand of Whirlpool Corporation. For support, visit www.hotpoint.eu or contact local service center.

Troubleshooting

Reset: Unplug for 5 minutes to reset electronic control.

Service: Contact authorized Hotpoint service center. Do not attempt repairs yourself.