Hotpoint washing machine RDG 8643 WW UK N manual

The Hotpoint RDG 8643 WW UK N is a freestanding washing machine with an 8kg capacity, energy rating A+++, 1400 rpm spin speed, and multiple wash programs including Cotton, Synthetics, Delicates, Wool, and Quick Wash. It features a digital display, delay timer, child lock, and anti-flood system. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: Drum, detergent dispenser, control panel, digital display, door, water inlet hoses, drain hose.

Installation

Unpack and remove transit bolts. Place on level floor.

1. Remove transit bolts: Use spanner to remove 4 bolts at rear; keep for future moves.
2. Connect water supply: Attach inlet hoses to cold water tap (blue) and hot if used (red).
3. Connect drain hose: Place in standpipe or sink; secure with U-bend.
4. Level the machine: Adjust feet until machine is stable; use spirit level.
5. Plug into grounded socket.

WARNING! Do not install in wet areas. Ensure transit bolts are removed to prevent damage.

First-Time Setup

Plug in and run initial empty wash.

1. Open water taps fully.
2. Add detergent: Pour into compartment II (main wash).
3. Select program: Turn knob to "Cotton 60°C".
4. Press Start/Pause to begin.
5. After cycle, machine is ready for use.

CAUTION! First wash may contain residual water; this is normal.

Specifications

• Model: RDG 8643 WW UK N
• Capacity: 8 kg
• Energy Class: A+++
• Annual Energy Consumption: 152 kWh
• Water Consumption: 9900 litres/year
• Spin Speed: 1400 rpm
• Noise Level (wash/spin): 53/76 dB(A)
• Programs: 15 including Cotton, Synthetics, Delicates, Wool, Quick Wash
• Dimensions: 850 x 596 x 545 mm (HxWxD)
• Power Supply: 220-240V, 50Hz

Controls and Settings

Control Panel: Program knob, digital display, temperature button, spin speed button, option buttons (Delay, Extra Rinse, etc.), Start/Pause.

Program Knob: Select from Cotton (20°C-90°C), Synthetics, Delicates, Wool, Quick 30', Drum Clean.

Temperature: Adjust with TEMP button (cold to 90°C).

Spin Speed: Adjust with SPIN button (0 to 1400 rpm).

Options: Delay (1-24h), Extra Rinse, Pre-Wash, Easy Iron.

Child Lock: Press and hold Delay + Spin for 3 seconds to activate/deactivate.

Connecting Water & Drain

Water Inlet: Connect hoses to taps (blue=cold, red=hot). Drain: Place hose in standpipe (max height 100 cm).

1. Ensure taps are off before connecting hoses.
2. Use new hoses; do not reuse old ones.
3. Secure drain hose to prevent slipping.
4. Check for leaks after first connection.

Tip: Do not kink hoses; ensure free flow.

Using Wash Programs

Select program based on fabric type.

1. Load laundry: Do not exceed 8 kg; distribute evenly.
2. Add detergent: Use compartment I for pre-wash, II for main wash, softener in *.
3. Select program: Turn knob (e.g., Cotton for cottons).
4. Adjust settings: Temperature, spin speed, options as needed.
5. Press Start/Pause.
6. At end, remove laundry promptly to avoid wrinkles.

WARNING! Do not wash waterproof items (e.g., raincoats) to avoid imbalance.

Special Features

Delay Timer: Set wash to start later (1-24h). Child Lock: Locks controls during cycle. Drum Clean: Run monthly with detergent to clean drum. Anti-Flood: AquaStop shuts off water if leak detected.

Care & Cleaning

Unplug before cleaning. Wipe exterior with damp cloth. Clean detergent drawer monthly. Run Drum Clean program monthly. Check drain filter every 3 months.

CAUTION! Do not use abrasive cleaners; keep control panel dry.

Regulatory Information

CE marked; complies with EU directives. Waste disposal: Contact local authority for recycling. For support, visit www.hotpoint.co.uk or contact 03448 113 113.

Troubleshooting

Reset: Unplug for 1 minute, then restart.

Service: 03448 113 113; www.hotpoint.co.uk