Hotpoint washing machine NDB 9635 BS UK manual

The Hotpoint NDB 9635 BS is a 9kg capacity freestanding washing machine with an A+++ energy rating, featuring 1600 RPM spin speed, multiple wash programmes including Eco 40-60, Quick Wash, and Delicates, a delay timer, child lock, and anti-flood protection. Designed for UK households, it offers efficient cleaning with low water and energy consumption. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Water & Drain 7. Using Wash Programmes 8. Special Features 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: 9kg drum, electronic control panel, detergent dispenser, filter, inlet hoses, drain hose.

FeatureDescription
Capacity9kg for large loads
Energy RatingA+++ for high efficiency
Spin SpeedUp to 1600 RPM for faster drying
Programmes16 programmes including Cotton, Synthetics, Delicates
Delay TimerUp to 24 hours delay start
Child LockPrevents accidental programme changes
Anti-Flood ProtectionLeak detection system
Quick Wash30-minute programme for lightly soiled items
Eco 40-60Energy-saving wash for 40°C and 60°C loads
DisplayLED with time remaining indicator

Installation

Unpack and inspect contents. Position on level, solid floor.

  1. Remove transit bolts: Use spanner to remove bolts at rear; keep for future moves.
  2. Connect water supply: Attach inlet hoses to cold water tap (and hot if applicable).
  3. Connect drain hose: Place into standpipe or sink; secure with hook if provided.
  4. Level the machine: Adjust feet until machine is stable; use spirit level.
  5. Plug into grounded socket.

WARNING! Do not install in areas below 0°C. Ensure transit bolts are removed before use.

First-Time Setup

Plug in and power on; run initial service wash.

  1. Run service wash: Select Cotton 90°C programme without laundry to clean drum.
  2. Set preferences: Use control dial and buttons to set time, etc.
  3. Load detergent: Add to appropriate dispenser compartment.
  4. Start first wash: Load laundry, select programme, press Start/Pause.

CAUTION! Ensure packaging is fully removed. Check for leaks after first connection.

Specifications

Controls and Settings

Control Panel: Programme dial, Start/Pause button, Delay button, Option buttons (e.g., Extra Rinse, Pre-Wash).

Display: Shows programme time, delay time, options selected.

Programme Selection: Turn dial to desired programme (e.g., Cotton, Synthetics). Options: Press relevant button to toggle features (e.g., Eco, Speed Wash). Delay Start: Press Delay button, use +/- to set hours. Child Lock: Press and hold Start/Pause and Delay for 3 seconds. Temperature/Spin: Adjust with corresponding buttons if available.

Connecting Water & Drain

Water Inlet: Connect hoses to taps (blue for cold, red for hot if dual supply). Drain: Place hose securely.

  1. Ensure taps are off before connecting hoses.
  2. Use only provided hoses; do not overtighten.
  3. Drain hose must not be higher than 100 cm from floor.
  4. After connection, open taps fully and check for leaks.

Tip: Use hose clips if supplied. Ensure drain hose is not kinked.

Using Wash Programmes

Supports various fabrics and soil levels.

  1. Load laundry: Do not overload; distribute evenly.
  2. Add detergent: Use drawer compartments (I=pre-wash, II=main wash, * =fabric softener).
  3. Select programme: Turn dial (e.g., Cotton for towels/bedding).
  4. Set options: Press buttons for extra rinse, lower spin, etc.
  5. Start: Press Start/Pause; display shows time remaining.
  6. Pause/change: Press Start/Pause to pause; turn dial to change programme (may reset).
  7. End of cycle: Machine beeps; remove laundry promptly to avoid creasing.

WARNING! Do not open door during high-temperature washes; wait for lock light to go off.

Special Features

Delay Start: Set up to 24 hours. Child Lock: Locks controls. Anti-Crease: Tumbles intermittently after cycle. Quick Wash: 30-minute cycle for small loads. Eco 40-60: Saves energy on mixed 40°C/60°C loads.

Care & Cleaning

Unplug before maintenance. Clean detergent drawer monthly; run drum clean programme every 30 washes.

CAUTION! Do not use abrasive cleaners. Check filter regularly for blockages.

Regulatory Information

Complies with UK Electrical Equipment Safety Regulations 2016. CE marked. Waste Electrical and Electronic Equipment (WEEE) Directive: Do not dispose with household waste; recycle appropriately. For support, visit www.hotpoint.co.uk or contact 03448 113 113.

Troubleshooting

SymptomPossible CauseCorrective Action
Machine won't startDoor not closed/powerClose door firmly; check plug socket; ensure child lock is off.
No water intakeTaps off/hose kinkedOpen taps; straighten hoses; check water pressure.
Leaking waterLoose connectionsTighten hoses; check detergent drawer is seated properly.
Excessive vibrationTransit bolts/levelingEnsure transit bolts removed; re-level machine; redistribute load.
Poor washing resultsOverload/detergentReduce load size; use correct detergent amount; select proper programme.

Reset: Unplug for 2 minutes, then restart.

Service: 03448 113 113; www.hotpoint.co.uk

Hotpoint washing machine NDB 9635 BS UK manual © - All Rights Reserved 2025