Hotpoint washing machine NSWA 843C WW UK manual

The Hotpoint NSWA 843C WW is a freestanding washing machine with an 8kg load capacity, 1400 RPM spin speed, and an A+++ energy rating. It features multiple wash programs, a digital display, delay start, child lock, and anti-flood protection. Designed for UK households, it operates on a standard 220-240V, 50Hz power supply. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: Digital control panel, detergent dispenser, drum, water inlet valves, drain pump, and adjustable feet.

Installation

Unpack and remove transit bolts. Place on level, solid floor.

1. Remove transit bolts: Use spanner to remove 4 bolts at rear; keep for future moves.
2. Level the machine: Adjust front feet; use spirit level.
3. Connect water supply: Attach inlet hose to cold water tap (3/4”); ensure washers are fitted.
4. Connect drain hose: Place into standpipe or sink; secure with U-bend.
5. Plug into grounded 3-pin socket.

WARNING! Do not install in areas below 0°C. Ensure transit bolts are removed before first use to prevent damage.

First-Time Setup

Plug in and run a maintenance wash before first laundry load.

1. Power on: Press POWER button; display will illuminate.
2. Run initial cycle: Select “Cotton 90°C” program without laundry and run to clean drum.
3. Set preferences: Use SETTINGS button to adjust buzzer volume, default spin speed, etc.
4. Load detergent: Fill compartments I (pre-wash), II (main wash), * (fabric softener).

CAUTION! Ensure all packaging and stickers are removed. Check for water leaks during first fill.

Specifications

• Model: NSWA 843C WW UK
• Capacity: 8 kg
• Spin Speed: 1400 RPM (adjustable)
• Energy Class: A+++ (EU 2019/2014)
• Water Consumption: ~50 litres per cycle (average)
• Noise Level: 74 dB (washing), 78 dB (spinning)
• Programs: Cotton, Eco Cotton, Synthetics, Delicates, Wool, Hand Wash, Quick 15’, Sport, Jeans, Anti-Allergy, Drum Clean
• Power Supply: 220-240V, 50Hz, 10A
• Weight: 70 kg

Controls and Settings

Control Panel: POWER, START/PAUSE, PROGRAM SELECTOR knob, OPTION buttons (Delay, Extra Rinse, etc.), CHILD LOCK.

Display Icons: Time remaining, spin speed, temperature, option indicators, door lock.

Program Selection: Turn knob to desired program (e.g., Cotton 40°C). Options: Press corresponding button to activate (e.g., Delay, Extra Rinse, Pre-Wash). Settings Menu: Hold SETTINGS for 3 seconds to access default spin, temperature, buzzer volume. Child Lock: Press and hold CHILD LOCK for 3 seconds; activates/deactivates.

Connecting Water & Drain

Cold water fill only. Drain hose can be fixed or placed in sink.

1. Ensure water tap is off before connecting hose.
2. Connect inlet hose to machine (red collar) and tap; hand-tighten.
3. Place drain hose in standpipe (height between 60-100 cm) or over sink edge.
4. Secure hose to prevent slipping.

Tip: Do not kink or bend hoses sharply. Check connections for leaks before first use.

Using Wash Programs

Select program based on fabric type and soil level.

1. Load laundry: Open door, load evenly, do not overload.
2. Add detergent: Pull dispenser drawer; fill appropriate compartments.
3. Select program: Turn knob (e.g., Synthetics 40°C).
4. Set options: Press Extra Rinse, Delay Start, etc. as needed.
5. Start: Press START/PAUSE; door locks and cycle begins.
6. Pause/Stop: Press START/PAUSE to pause; turn knob to reset to stop.
7. End of cycle: Buzzer sounds; door unlocks after a few minutes.

WARNING! Do not open door during high-temperature washes; hot water/steam risk. Unbalanced load may cause vibration; redistribute laundry.

Special Functions

Delay Start: Set delay up to 24 hours. Extra Rinse: Adds rinse cycle for sensitive skin. Pre-Wash: For heavily soiled loads. Drum Clean: Run monthly with dedicated cleaner or 90°C cotton program empty. Child Lock: Locks controls; hold button 3 sec to enable/disable.

Care & Cleaning

Unplug before maintenance. Wipe exterior with damp cloth. Clean detergent drawer monthly; remove and rinse under tap. Clean door seal and glass; remove lint/debris. Run Drum Clean program monthly. Leave door ajar after use to prevent odours.

CAUTION! Do not use abrasive cleaners or solvents. Never hose down the machine.

Regulatory Information

UKCA/CE marked. Complies with UK Electrical Equipment (Safety) Regulations 2016. Manufacturer: Hotpoint, a Haier company. For support, visit www.hotpoint.co.uk or contact 0333 305 2265. Keep this manual for future reference. Disposal: At end of life, dispose at designated WEEE collection points.

Troubleshooting

Reset: Unplug for 5 minutes, then restart.

Service: 0333 305 2265; www.hotpoint.co.uk