Hotpoint washing machine HDA2000ZWH manual

The Hotpoint HDA2000ZWH is a 7kg capacity front-loading washing machine with 1200 RPM spin speed, A+++ energy rating, and multiple wash programs. It features Hotpoint's Anti-Stain technology, direct injection motor, LED display, delay start, child lock, and quick wash cycles. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Utilities 7. Using Wash Programs 8. Special Functions 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Front-loading drum, control panel with LED display, detergent drawer, water inlet valves, drain pump, and adjustable feet.

FeatureDescription
Capacity7kg laundry load
Spin SpeedUp to 1200 RPM
Energy RatingA+++ (most efficient)
Anti-Stain TechnologyAutomatic stain removal optimization
Direct Injection MotorQuiet and efficient operation
LED DisplayShows time remaining, program, and settings
Delay StartProgram start delay up to 24 hours
Child LockPrevents accidental program changes
Quick Wash30-minute cycle for lightly soiled items
Detergent DrawerCompartments for pre-wash, main wash, and softener

Installation

Unpack and inspect contents. Place on level, solid floor.

  1. Remove transit bolts: Use spanner to remove 4 bolts at rear; keep for future moves.
  2. Adjust feet: Turn clockwise to raise, counterclockwise to lower; ensure machine is level.
  3. Connect water supply: Attach inlet hose to cold water tap (3/4" connection).
  4. Connect drain hose: Place in standpipe or sink (minimum height 60cm).
  5. Plug into grounded power outlet.

WARNING! Do not install in areas below 0°C. Ensure transit bolts are removed before use.

First-Time Setup

Power on machine; run initial setup cycle.

  1. Run empty wash: Select Cotton program at 90°C without laundry to clean drum.
  2. Set preferences: Use PROGRAM knob and OPTIONS buttons to configure default settings.
  3. Test functions: Check delay start, child lock, and spin speed settings.
  4. Load laundry: Do not exceed 7kg; distribute evenly in drum.

CAUTION! Use only HE (High Efficiency) detergent. Overloading may cause damage.

Specifications

Controls and Settings

Control Panel: PROGRAM knob, START/PAUSE button, OPTIONS buttons, LED display.

Programs: Cotton (20°C-90°C), Synthetic (30°C-60°C), Delicate (cold-30°C), Wool (cold), Quick Wash (30°C), Anti-Stain (40°C-60°C), Rinse & Spin. Options: Extra Rinse, Pre-Wash, Delay Start (1-24h), Speed (400-1200 RPM), Child Lock (press 3 sec). Display: Shows time remaining, program, selected options.

Connecting Utilities

Water: Cold fill only. Drain: Standpipe or sink. Power: Grounded outlet.

  1. Turn off water and power before connecting.
  2. Ensure hose connections are tight; check for leaks.
  3. Drain hose must not be submerged in water.
  4. Do not use extension cords; plug directly into outlet.

Tip: Install water hammer arrestor if pipes make noise during fill.

Using Wash Programs

Select program based on fabric type and soil level.

  1. Load laundry: Open door, distribute items evenly, close securely.
  2. Add detergent: Pour into correct drawer compartment (II for main wash).
  3. Select program: Turn PROGRAM knob to desired cycle.
  4. Set options: Press OPTIONS for extra rinse, delay, etc.
  5. Start: Press START/PAUSE; display shows time remaining.
  6. Pause: Press START/PAUSE to stop; press again to resume.
  7. End of cycle: Machine beeps; remove laundry promptly.
  8. Unload: Open door, remove items, leave door ajar to dry drum.

WARNING! Do not open door during spin cycle. Wait for door lock light to go off.

Special Functions

Anti-Stain Technology: Automatically adjusts time, temperature, and motion for 30 common stains. Delay Start: Set wash to begin later (1-24 hours). Child Lock: Press and hold for 3 seconds to lock controls. Quick Wash: 30-minute cycle for 2kg lightly soiled cotton.

Care & Cleaning

Monthly maintenance: Clean detergent drawer, door seal, and drum.

  1. Detergent drawer: Remove, rinse under warm water, dry, reinsert.
  2. Door seal: Wipe with damp cloth; remove debris from folds.
  3. Drum: Run empty hot wash (90°C) with washing machine cleaner.
  4. Filter: Clean drain pump filter every 3 months (see manual).

CAUTION! Unplug before cleaning. Do not use abrasive cleaners on door or display.

Regulatory Information

CE certified; complies with EU directives for safety and electromagnetic compatibility. Energy label class A+++. Manufactured by Hotpoint, a brand of Whirlpool Corporation. For support, visit www.hotpoint.eu or contact 0800 316 1444 (UK).

Troubleshooting

SymptomPossible CauseCorrective Action
Machine won't startDoor not closed/powerClose door securely; check power outlet; press START/PAUSE.
No water intakeTap closed/hose kinkedOpen water tap; straighten hose; check filter.
Water doesn't drainDrain blocked/filter cloggedClean drain pump filter; ensure hose not submerged.
Excessive vibrationTransit bolts/uneven loadRemove transit bolts; level machine; redistribute laundry.
Error codes (E01-E10)Various faultsConsult manual; unplug for 5 minutes; restart.

Reset: Unplug for 5 minutes, then restart.

Service: 0800 316 1444; www.hotpoint.eu

Hotpoint washing machine HDA2000ZWH manual © - All Rights Reserved 2025