Hotpoint washing machine AQS73F 09 EU manual

The Hotpoint AQS73F 09 EU is a freestanding washing machine with a 7kg load capacity, A+++ energy rating, and 1400 RPM spin speed. It features multiple wash programs, electronic controls, delay start, child lock, and anti-flood protection. Designed for EU household use, it operates on 230V~50Hz. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: Electronic control panel, detergent dispenser, drum, water inlet valves, drain pump, adjustable feet, and power cord.

Installation

Unpack and remove transit bolts. Place on level, solid floor.

1. Remove transit bolts: Use spanner to remove 4 bolts at rear; keep for future moves.
2. Adjust feet: Turn feet to level machine; use spirit level.
3. Connect water supply: Attach inlet hoses to hot/cold taps (blue=cold, red=hot).
4. Connect drain hose: Place in standpipe or sink (max height 100 cm).
5. Plug into grounded power outlet.

WARNING! Do not install in wet areas. Ensure transit bolts are removed before first use to prevent damage.

First-Time Setup

After installation, run a maintenance wash.

1. Power on: Plug in and press POWER button.
2. Select program: Turn program selector to "Cotton 90°C".
3. Add detergent: Pour 100g of powder detergent into compartment II.
4. Start: Press START/PAUSE; let cycle complete without laundry.
5. Set preferences: Use OPTIONS button to set beep volume, etc.

CAUTION! Ensure all packaging and transit bolts are removed. Check for water leaks during first fill.

Specifications

• Model: AQS73F 09 EU
• Capacity: 7kg
• Energy Class: A+++
• Annual Energy Consumption: 150 kWh
• Water Consumption: 45 litres per cycle (cotton 60°C)
• Spin Speed: 1400 RPM (adjustable)
• Noise Level: 53 dB (washing), 73 dB (spinning)
• Programs: 15 including Eco 40-60, Wool, Sport, Drum Clean
• Power Supply: 230V~, 50Hz, 10A
• Weight: 69 kg

Controls and Settings

Control Panel: POWER button, program selector knob, START/PAUSE, OPTIONS, delay start button, spin speed button, temperature button.

Programs: Cotton (20°C-90°C), Synthetic, Delicate, Wool, Quick Wash (30 min), Eco 40-60, Sport, Drum Clean, Rinse & Spin, Spin Only.

Options: Delay Start (1-24h), Extra Rinse, Pre-Wash, Speed Wash, Silent Mode. Settings: Child Lock (press TEMP + SPIN for 3 sec), beep volume, end-of-cycle signal.

Connecting Water & Drain

Water Inlet: Two hoses (hot/cold) with filters. Drain: Hose with U-shape hook.

1. Turn off water taps before connecting.
2. Connect hoses: Screw onto taps; hand-tighten only.
3. Check filters: Ensure inlet filters are clean.
4. Position drain hose: Secure in standpipe (min 60 cm height) or over sink edge.
5. Test: Run quick wash to check for leaks.

Tip: Use new hoses; replace every 5 years. Do not kink hoses.

Using Wash Programs

Follow fabric care labels.

1. Sort laundry: By colour and fabric type.
2. Load: Open door, place items loosely in drum; do not overload.
3. Add detergent: Use compartment I for pre-wash, II for main wash, * for softener.
4. Select program: Turn knob to desired program.
5. Adjust: Use TEMP, SPIN, OPTIONS buttons as needed.
6. Delay start: Press DELAY to set start time (if required).
7. Start: Press START/PAUSE; display shows time remaining.
8. Unload: When cycle ends, door unlocks (wait 2 min if hot). Remove laundry promptly.

WARNING! Do not wash items soaked in solvents. Remove coins, keys from pockets.

Safety Features

Child Lock: Locks controls during wash (press TEMP + SPIN 3 sec). Door Lock: Automatically locks during wash; unlocks at end. Anti-Flood: AquaStop™ shuts off water if leak detected. Overheating Protection: Thermal cut-out prevents motor overheating. Unbalanced Load Detection: Reduces spin speed if load uneven.

Care & Cleaning

Monthly maintenance:

1. Clean detergent drawer: Remove and rinse under water.
2. Clean door seal: Wipe rubber gasket to remove lint/debris.
3. Clean filter: Turn off machine; open filter cover at front; place towel; unscrew filter; clean; reinsert.
4. Run Drum Clean program: Every 30 washes (without laundry).

CAUTION! Unplug before cleaning. Do not use abrasive cleaners.

Regulatory Information

CE Mark: Complies with EU directives. Waste Electrical: Dispose according to local regulations. Manufacturer: Hotpoint, a Haier company. For EU product registration, visit www.hotpoint.eu/register. Energy label according to EU Regulation 2019/2014. Noise emission declared in accordance with ISO 3744. For support, visit www.hotpointservice.com or contact local service centre.

Troubleshooting

Reset: Unplug for 5 minutes, then restart.

Service: Contact authorised Hotpoint service centre. Keep model number ready.