Hotpoint washing machine RDD 966238 WS VJ EU manual

The Hotpoint RDD 966238 WS VJ EU is a freestanding washing machine with a 9kg capacity, 1400 RPM spin speed, and energy rating A+++. It features multiple wash programs, delay start, child lock, anti-flood protection, and direct injection motor technology. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Water & Drain 7. Using Wash Programs 8. Special Functions 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Control panel with rotary selector and digital display, detergent dispenser, drum, motor, water inlet valves, drain pump.

FeatureDescription
Capacity9 kg maximum load
Spin SpeedUp to 1400 RPM
Energy ClassA+++ (most efficient)
Programs15+ including Cotton, Synthetics, Delicates, Quick Wash
Delay StartUp to 24 hours
Child LockPrevents accidental program changes
Anti-FloodAquaStop™ protection system
MotorDirect Drive motor for quiet operation
DisplayLED with time remaining, cycle stage
DoorReversible, wide opening

Installation

Unpack and remove transit bolts. Place on level, solid floor.

  1. Remove transit bolts: Use spanner to remove 4 bolts at rear; keep for future moves.
  2. Connect water supply: Attach inlet hose to cold water tap (3/4” thread). Ensure washers are fitted.
  3. Connect drain hose: Place in standpipe or sink edge; secure with U-bend.
  4. Level the machine: Adjust front feet; use spirit level.
  5. Plug into grounded power outlet.

WARNING! Do not install in areas below 0°C. Ensure transit bolts are removed before use.

First-Time Setup

Plug in and run a maintenance wash.

  1. Initial power on: Plug in; machine may beep. Turn selector knob to any program.
  2. Run empty wash: Select “Cotton 90°C” without laundry; add 100ml detergent to drum.
  3. Set preferences: Use “Settings” button to set buzzer volume, end-of-cycle signal.
  4. Load laundry: Do not exceed 9 kg; mix large and small items.

CAUTION! First use may produce slight odor; this is normal.

Specifications

Controls and Settings

Control Panel: Rotary selector, START/PAUSE, OPTIONS, SETTINGS, display.

Rotary Selector: Turn to choose program. Display shows duration, temperature, spin speed.

OPTIONS: Extra rinse, pre-wash, stain removal, speed wash. SETTINGS: Buzzer volume, child lock (press 3 sec), reset defaults. Temperature: 20°C to 90°C. Spin Speed: 400 to 1400 RPM or no spin. Delay Start: 1 to 24 hours.

Connecting Water & Drain

Cold water fill only. Drain hose maximum height 100 cm.

  1. Water inlet: Connect blue-marked hose to cold tap. Do not use with hot water.
  2. Drain hose: Insert into standpipe (min diameter 4 cm) or over sink edge.
  3. Check for leaks: Run a short cycle after connections.

Tip: Use hose clips provided. Do not kink hoses.

Using Wash Programs

Select program based on fabric type.

  1. Load laundry: Open door, load mixed items, close firmly.
  2. Add detergent: Pour into dispenser drawer (I: pre-wash, II: main wash, *: softener).
  3. Select program: Turn knob (e.g., Cotton for towels/bed linen).
  4. Adjust settings: Press TEMP/SPIN to change temperature/spin speed.
  5. Add options: Press OPTIONS for extra rinse, etc.
  6. Start: Press START/PAUSE. Display shows time remaining.
  7. Pause/change: Press START/PAUSE to stop; turn knob to new program within 1 minute.
  8. End of cycle: Buzzer sounds; door unlocks after a few minutes.

WARNING! Do not open door during high-temperature wash; steam may escape.

Special Functions

Delay Start: Set 1-24 hours; machine starts automatically. Child Lock: Press SETTINGS 3 sec; locks controls. Drum Clean: Run monthly without laundry at 90°C with detergent.

Care & Cleaning

Unplug before maintenance. Clean detergent drawer monthly; wipe door seal; run Drum Clean program.

CAUTION! Do not use abrasive cleaners. Keep filter area clear.

Regulatory Information

CE marked. Complies with EU directives for safety (LVD, EMC) and eco-design. Manufactured by Hotpoint, a brand of Whirlpool Corporation. For support, visit www.hotpoint.eu or contact local service center.

Troubleshooting

SymptomPossible CauseCorrective Action
Machine does not startPower, door, child lockCheck plug; close door firmly; disable child lock.
No water intakeTaps, hose, filterOpen taps; check hose for kinks; clean inlet filter.
Water does not drainDrain hose, pump filterCheck hose height/blockage; clean pump filter.
Excessive vibration/noiseTransit bolts, leveling, loadEnsure bolts removed; re-level; redistribute load.
Error codes (e.g., F01, F05)Sensor/motor faultsUnplug for 5 min; restart. If persists, call service.
Detergent not dispensedDrawer blockedRemove drawer; rinse under water.

Reset: Unplug for 5 minutes, then restart.

Service: See warranty card; authorized service centers listed on website.

Hotpoint washing machine RDD 966238 WS VJ EU manual © - All Rights Reserved 2025