Hotpoint washing machine WMFUG 863P UK manual

The Hotpoint WMFUG 863P is a freestanding 8kg capacity washing machine with 1400 RPM spin speed, featuring Hotpoint's Anti-Stain Technology, Direct Spray for efficient rinsing, a large porthole door, intuitive digital display with rotary dial, multiple wash programmes including a 15-minute quick wash, delay timer, and energy efficiency class A+++. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Water & Drain 7. Using Wash Programmes 8. Care & Maintenance 9. Safety Information 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: 8kg drum capacity, 1400 RPM spin, Digital display, Programme selector dial, Direct Spray system, Anti-Stain technology, Delay timer, Child lock, Large door with glass porthole.

Feature	Description
Capacity	8kg (cotton) for large loads
Spin Speed	Up to 1400 RPM for faster drying
Anti-Stain Technology	Targets specific stains (grass, wine, oil, etc.)
Direct Spray	Continuous water spray during rinse for better detergent removal
Quick Wash	15-minute programme for lightly soiled items
Delay Timer	Delay start up to 24 hours
Digital Display	Shows time remaining, cycle stage, and settings
Programme Dial	Select from 14 programmes including Cotton, Synthetics, Delicates
Energy Rating	A+++ for energy efficiency
Child Lock	Locks controls during operation

Installation

Unpack and remove all transit bolts and packaging. Place on a solid, level floor.

Position the machine: Ensure at least 1cm space at sides and back for ventilation.
Connect water supply: Attach inlet hoses to cold water tap (and hot if applicable) using supplied connectors.
Connect drain hose: Place into standpipe (min height 60cm, max 100cm) or secure over sink edge.
Level the machine: Adjust front feet to ensure machine is stable; use a spirit level.
Remove transit bolts: Use spanner to remove four bolts at rear; keep bolts for future moves.
Plug into a grounded 220-240V, 50Hz power outlet.

WARNING! Do not install in areas below 0°C. Ensure transit bolts are removed before use to prevent damage.

First-Time Setup

Before first wash, run a maintenance cycle to clean the drum.

Ensure machine is installed correctly, hoses are secure, and transit bolts removed.
Turn on water supply and plug in the machine.
Open detergent drawer and pour 100ml of bleach into compartment II (no clothes).
Select the "Drum Clean" programme (or Cotton 90°C if no specific programme).
Press Start/Pause. Let the cycle complete.
After cycle, leave door open to air dry the drum.

CAUTION! Never use the machine without removing transit bolts. Ensure the drain hose is not kinked.

Specifications

Model: Hotpoint WMFUG 863P UK
Capacity: 8kg (cotton)
Spin Speed: 1400 RPM (adjustable)
Dimensions (HxWxD): 85cm x 60cm x 60cm
Water Pressure: 0.5 bar - 8 bar
Power Supply: 220-240V, 50Hz
Energy Class: A+++
Noise Level (wash/spin): 56dB / 76dB
Programmes: 14 including Cotton, Eco Cotton, Synthetics, Delicates, Wool, Quick 15', Anti-Stain, Drum Clean
Features: Delay timer (up to 24h), Child Lock, Anti-Crease, Extra Rinse, Pre-Wash

Controls and Settings

Control Panel: Programme selector dial, Digital display, Start/Pause button, Option buttons (Delay, Extra Rinse, Pre-Wash, etc.), Spin speed reduction button, Temperature button.

Using the Controls: Turn dial to desired programme. Display shows default time, temperature, spin speed. Use Temperature and Spin buttons to modify. Press Delay to set start time (LEDs show hours). Select any extra options (e.g., Extra Rinse). Press Start/Pause to begin.

Child Lock: Press and hold Delay and Spin Speed buttons for 3 seconds to activate/deactivate. Icon appears on display.

Connecting Water & Drain

Water Inlet: Connect blue-marked hose to cold water tap. If machine has dual inlet (hot & cold), connect red hose to hot tap. Use supplied aquastop connectors.

Ensure taps are off. Screw hoses onto taps; hand-tighten, then a quarter turn with pliers.
Connect other ends to machine inlet valves (cold = left, hot = right).
Drain hose: Insert into standpipe (diameter at least 4cm) between 60cm and 100cm from floor. Alternatively, use U-bend hook over sink edge.
Secure hose to prevent slipping.

Tip: Check for leaks by turning on taps before starting machine. Never extend inlet hoses.

Using Wash Programmes

Select programme based on fabric type and soil level.

Load laundry: Do not overload. Mix large and small items.
Add detergent: Pour powder/liquid into compartment I (main wash). For pre-wash, add to compartment II. Softener to compartment III (max MAX line).
Close door firmly.
Select programme: Turn dial (e.g., Cotton 40°C for coloured cottons).
Adjust settings: Use Temp button to lower temperature if needed. Use Spin button to reduce spin speed for delicate items.
Set Delay (optional): Press Delay button until desired start time LED lights.
Press Start/Pause. Machine will lock door, fill, and begin cycle. Display shows time remaining.
At end of cycle, "End" appears. Door unlocks after a short delay. Remove laundry promptly.

WARNING! Do not open door during high-temperature washes. Wait until "End" appears and door unlocks.

Care & Maintenance

Clean detergent drawer monthly: Pull out drawer, press release catch, wash under warm water.

Clean door seal: Wipe rubber gasket to remove lint and residue; check for foreign objects.

Clean filter: Locate filter behind small flap at bottom front. Place towel, turn filter anti-clockwise to remove, clean under running water, reinsert and tighten.

Descale: Run a 90°C cotton cycle with descaling agent (no laundry) every 2-3 months in hard water areas.

CAUTION! Unplug machine before cleaning. Do not use abrasive cleaners.

Safety Information

This appliance must be grounded. Use a dedicated socket. Do not use extension cords.

Do not wash items soiled with flammable substances (petrol, oil, etc.).

Keep packaging materials away from children.

Child safety: Use Child Lock feature. Supervise children near the appliance.

Disposal: At end of life, disconnect power and cut power cord. Dispose according to local WEEE regulations.

Regulatory Information

Complies with EC Directives 2014/35/EU (Low Voltage), 2014/30/EU (EMC), 2009/125/EC (Ecodesign), and 2010/30/EU (Energy Labelling). UKCA marked. Manufacturer: Hotpoint, Peterborough, PE2 9JB, UK. For support, visit www.hotpoint.co.uk or contact 03448 225 225.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Machine won't start	Door not closed, no power, Child Lock on	Close door firmly, check plug/power, deactivate Child Lock.
No water intake	Taps off, kinked hose, filter blocked	Open taps, straighten hose, clean inlet filter (at tap connection).
Machine doesn't drain/spin	Drain hose blocked/kinked, pump filter blocked	Check hose position/blockages, clean pump filter.
Excessive vibration/noise	Transit bolts not removed, uneven load, uneven floor	Remove transit bolts, redistribute load, level the machine.
Water leaks	Loose hose connections, damaged door seal, overfilled detergent	Tighten hoses, check seal, use recommended detergent amount.
Display shows error code (e.g., F01, F05)	Various faults (drain, motor, etc.)	Consult manual error code list. Unplug for 1 minute, restart. If persists, call service.

Reset: Unplug for 5 minutes to reset electronic control.

Service: 03448 225 225; www.hotpoint.co.uk. Have model and serial number ready.